See Diagram 7 & Cable Loop Diagram | Impex EVE-900 specification

STEP 7 (See Diagram 7 & Cable Loop Diagram)

A.)	Attach the 144” Lower Cable (#59) to the opening on the bottom of the Leg
	Developer (#9).
B.)	Attach a Pulley (#41) to the opening. Secure it with one M10 x 2 ½” Allen Bolt
	(#64), two ∅ 7/8” Pulley Bushings (#35), and one M10 Aircraft Nut (#81).
C.)	Draw the Cable underneath the Pulley towards the back of the machine through
	the opening on the bottom of the Main Base Frame (#1) to an open bracket.
D.)	Attach a Pulley to the bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#65),
	two Ø ¾” Washers (#77), and one M10 Aircraft Nut (#81).
E.)	Draw the Cable underneath the Pulley towards the back of the machine to the
	Pulley Bracket (#18) underneath the Main Base Frame.
F.)	Attach a Pulley to the bracket. Secure it with one L-shaped Bracket (#23), one
	M10 x 2” Allen Bolt (#66), two ∅ ¾” Washers (#77), and one M10 Aircraft Nut
	(#81).
G.)	Pull the Cable upward to the Angled Double Floating Pulley Brackets (#15)
	previously installed in Step 6. Repeat Step D to install another Pulley.
H.)	Draw the Cable around the Pulley then pull downward to the open bracket on the
	Main Base Frame. Repeat Step D to install another Pulley.
I.)	Draw the Cable around the Pulley then pull upward to the Double Floating Pulley
	Bracket (#14) previously installed in Step-5. Repeat Step D to install a Pulley.
J.)	Draw the Cable around the Pulley then pull downward to the bracket on the rear
	of Main Base Frame. Attach the Cable to a 6-Joint Chain (#25) using a C-clip
	(#28). Secure the other end of the Chain to the bracket with a M10 x 1” Allen
	Bolt (#72), two ∅ ¾” Washers (#77) and one M10 Aircraft Nut (#81).
K.)	Use the length of the Chain to adjust the tension of the Cable Loop System. If
	the Cables are too loose, shorten the Chain.
L.)	Attach the 15-Joint Chain (#27) to the end of the Cable by using a C-clip. Attach
	the Arm Curl Handle (#12) to the Chain by using another C-clip. Replace Arm
	Curl Handle with the Ankle Strap (#82) for various Leg exercises. Adjust the
	length of Chain to obtain the desired exercise. Remove the Arm Curl Handle and
	Ankle Strap when using the Leg Developer.