JVC UX-M5 manual Setting the Clock

Common Operations	Continued
Turning On or Off the Unit	notes

To turn on the unit

Press	STANDBY/ON on the		STANDBY/ON
unit or remote control.		/ON	or
		STANDBY
The unit turns on with the last source
selection remaining valid.

To turn off the unit (on standby)

Press STANDBY/ON on the unit or remote control. The clock time appears if the clock is already set.

Setting the Clock

Before operating the unit any further, first set the built-in clock.

1 When the unit is in standby	PROGRAM
mode, press and hold
PROGRAM until the hour
indication starts blinking.

•When the unit is on, press DISPLAY MODE to enter clock mode, then press and hold PROGRAM.

2 Press 4 or ¢ to set the	SEARCH/TUNING
hour, then press
PROGRAM.

On clock resetting

If a power failure occurs or the AC power cord is disconnected, the clock is reset to “00:00” (flashing). In such a case you need to set the clock again.

Adjusting the Volume

• You can adjust the volume only while the unit is turned on.

Press VOLUME + or
VOLUME – to increase or	VOLUME
decrease the volume level.

The volume can be adjusted in 41 steps between “VOL MIN” (minimum) and “VOL MAX” (maximum).

To increase or decrease the volume level rapidly, press and

hold VOLUME + or VOLUME –.

To turn off the sound temporarily

Press MUTING on the remote control.	MUTING
Playback continues without sound and
“MUTING” appears on the display.

To restore the sound, press MUTING again or increase or decrease the volume level.

The minute indication starts blinking.

3 Press 4 or ¢ to set the	SEARCH/TUNING
minute, then press
PROGRAM to store the
setting.
The clock starts working.

To change the hour or minute indication rapidly in steps 2 and 3, press and hold 4 or ¢.

notes

For private listening

Connect a pair of headphones to the PHONES jack. No sound comes out of the speakers. Be sure to turn down the volume before connecting or putting on headphones.

DO NOT turn off the unit (on standby) with the volume set to an extremely high level; otherwise, a sudden blast

of sound can damage your hearing and/or the speakers when you turn on the unit or start playing any source next time.

To select 12-hour or 24-hour display mode

In standby mode, hold down

7 and press PROGRAM on the	STOP/CLEAR	PROGRAM
		and
unit repeatedly.
With each press, the selection
toggles between 12-hour and 24-
hour modes.

•In 12-hour mode, “AM 12:00” indicates midnight and “PM 12:00” indicates noon.

To check the clock time while the unit is on

Press DISPLAY MODE.

The clock time is displayed until you	DISPLAY
	MODE
press any key.

To correct the clock time

Carry out steps 1 to 3 above.

English

– 8 –