Oregon Scientific RX109 user manual Timer, Temperature Display, ALTI-BARO Mode

Page 10

GB

TIMER

The Timer works in CLOCK, ALTI-BARO, CARDIO, and BIKE modes. From any of these Modes, press SELECT/+ to display the stopwatch. Press FUNC/SET to reset the Stopwatch, then:

•Press and hold FUNC/SET for 2 sec- onds. The display will change to TMR.

•Press ST/SP/- or SELECT/+ to change a value.

•Press FUNC/SET to switch between values and accept changes.

•Press ST/SP/- to start or stop the timer.

•With the timer stopped, press and hold FUNC/SET to reset.

NOTE You can switch to other Modes while running the timer in the background.

NOTE To return to STW Mode, you must reset all the timer values to 0. The timer automatically switches to STW Mode when it reaches 0.

TEMPERATURE DISPLAY

The Temperature can be displayed in CLOCK, ALTI-BARO, CARDIO, and BIKE Modes. From any of these Modes, press SELECT/+ to dis- play the Temperature. The Temperature shows in either Celsius or Fahrenheit, depending on the measurement unit you select when setting the CLOCK (see CLOCK Mode).

NOTE Your wrist temperature may affect the reading, particu- larly during exercise. Take off the watch and leave it for 15 minutes to get the most accurate reading.

ALTI-BARO MODE

The OUTBREAKER sports watch includes a barometer that distinguishes between pres- sure caused by altitude changes and pressure caused by weather conditions. This technol- ogy reduces discrepancies in readings and makes the altimeter more accurate than most average devices.

The watch can store and recall the following values:

•Current altitude (updated every 2 seconds)

•Maximum / minimum altitudes attained during your a trip

•Total accumulated maximum / minimum altitudes attained during your trip

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Table of Contents Introduction View speed and cadence informationDescription KEY FeaturesOutbreaker Watch Chest Belt NameLCD Display Symbols Description PC KIT RP109 only NameReceiver Bike Mount low battery Stopwatch can be started/stopped/resetChange resolution of readings on altimeter Sxxx Speed sensor low batteryHOW the ALTIMETER, THERMOMETER, and Barometer Work Tour ModeHOW the Outbreaker Works MULTI-SYSTEM Facility Batteries Getting Started Turn on the Watch FIRST-TIME USE only Change Setting Values Switch Between ModesSwitch Between Mode Options USE the HI-GLO BacklightDiagram Instructions Clock ModeSET the Alarm StopwatchTemperature Display TimerALTI-BARO Mode SET Current Altitude and Resolution Accessing the Altimeter OptionsALT mode SET Altitude Alert SET the SEA-LEVEL PressureView the SEA-LEVEL Pressure AL or deactivated NoALRecalling Altitude Data Switch Between View OptionsWeather Forecast Tour Memory Tour ModeModel Total recording time available Pause Tour Mode Activate Tour ModeRecord Markers in Tour Mode Deactivate Tour ModeEither Cardio Heart Rate ModeClear ALL Tour Memories Outbreaker watch isWearing the Chest Belt Training ZonesLower limit Upper limit SET Upper and Lower Heart Rate Limits for Training ZoneSex DescriptionTrack Heart Rate During Training Activate the Training Zone AlarmPress ST/SP/- to turn the alarm off or on Press FUNC/SETSET UP for Bike Mode Bike Mode RP109 onlyAttach the Equipment to the Bicycle Enter Wheel Circumference PC KIT RP109 only Accessing the Mode OptionsViewing Speed and Cadence Information PC Mode Options PC ModeSET UP for PC Mode Using the SoftwareDownload Data Effective USE and RangeAquatic and Outdoor Activities Safety Precautions Safety and Care InstructionsCare Instructions Troubleshooting Guide Problem Symptom Check this RemedyHeart Rate Monitor SpecificationsCalendar Clock ThermometerBarometer Tour ModePower Bike ComputerDeclaration of Conformity Additional Resources Oregon Scientific. All rights reserved
Top Page Image Contents