once to stop counting and then press S2 button again.
5. Upon completion of a countdown, if STOP is selected as the action to be taken, the TIMER stops at zero ,a tune will be emitted and the backlight will flash; if REPEAT is selected, the TIMER repeats its countdown with the rep number updated. If the TIMER reset time is less than 30 seconds, a beep will be emitted. Otherwise, a tune will be emitted and the backlight will flash.
TO SET THE HEAT TIMER
1. Press S3 button to select HEAT TIMER mode.
2. Press S4 button, the “SET” message appears and the Minute digits blink on the display.
3. Press S1 button to increase the digits by five units, or press S2 button to decrease the digits by five units. Holding down either button will speed up the process.
4. After finished making all the settings, press S4 button to confirm the settings.
NOTE: The HEAT TIMER can count up to a maximum time of 35.00 (35minutes).
TO USE THE HEAT TIMER
1. Press S3 button to select HEAT TIMER mode.
2. Press S1 button to start a countdown.
3. To stop counting, press S2 button once. Press S1 button to resume from where it left off.
4. To reset the HEAT TIMER, press S2 button once to stop counting and then press S2 button again.
5. Upon completion of a countdown, a tune will be emitted and the backlight will flash.
NOTE: The HEAT TIMER is independent of the TIMER. Both may be running at the same time.
TO SET THE ALARM TIME
1. Press S3 button to select ALARM mode.
2. Press S4 button, the “SET” message appears and the alarm entry to set blinks on the display.
3. Press S1 button or S2 button to toggle between ALARM 1 and ALARM 2.
4. Press S3 button, the Hour digits (including AM/PM for
5. Press S1 button to increase the digits by one unit, or press S2 button to decrease the digits by one unit. Holding down either button will speed up the process.
6. Press S3 button, the Minute digits will blink.
7. Press S1 button or S2 button to set the Minute digits.
8. Press S3 button, the alarm frequency will blink.
9. Press S1 button or S2 button to cycle forward or backward respectively the alarm frequency
to be selected (DAILY, WEKDAYS, WEEKENDS, day of the week and WKLY).
10.After finished making all the settings, press S4 button to confirm the settings.
NOTE: The ALARM TIME displayed is in the same Time Format as the primary time.
NOTE: A tune will go off and the backlight will flash for 20 seconds at the designated time when the ALARM is activated.
NOTE:The alarm will automatically be activated after being set.
WHEN AN ALARM OR HOURLY CHIME GOES OFF
A tune will go off by the hour if the Hourly Chime function is activated and the same will happen at the designated time when the ALARM is activated. To stop the tune, press any button.
If the alarm tune is done without any user interruption, the watch will automatically enter a snooze mode. The ALARM will go off again after 5 minutes but for only once.
TO USE THE BACKLIGHT Press S5 button to turn on the backlight for three seconds.
To reduce carbon foot print, these Freestyle instructions are printed with soy inks on recycled paper.