JVC KT-SR3000 manual How the S-Seek function works, If you have already stored 20 PDTs

If you have already stored 20 PDTs...

“S-Seek Full” will flash on the display for a while, then the “Replace-Cancel” screen appears.

P

1. Press CH 5 / ∞ (or CH + / –) to select either “Replace” or “Cancel”, then press SEL (or SELECT).

•Replace: To select a previous PDT to be replaced with the new PDT.

After pressing SEL (or SELECT), the following screen appears.

Press CH 5 / ∞ (or CH + / –) to select an unnecessary PDT, then press SEL (or SELECT). It will be replaced with the new PDT.

•Cancel: Not to store the new PDT. The original screen will be resumed.

How the S-Seek function works

Your JVC PnP automatically searches for the incoming signal to determine if a match exists between the signal and the PDTs stored in memory (except the ones with “S-Seek” set to “Off”: see the next page).

•If one or more matches are found, “S-Seek Alert” appears for a while, and a beep sounds.

•The current channel will continue to play until you select a new channel.

P

24