Raleigh 2008 manual Appendix C, Front Wheel Secondary Retention Devices

Page 28

Appendix C

Wheel and Seat Post Quick Release Mechanisms

A. Quick Release Wheels

1.How a Wheel Quick Release Works

!WARNING: Riding with an improperly adjusted wheel quick release can allow the wheel to wobble or disengage from the bicycle, causing serious injury or death to the rider. Therefore, it is essential that you:

1.Ask your dealer to help you make sure you know how to install and remove your wheels safely.

2.Understand and apply the correct technique for clamping your wheel in place with a quick release.

3.Each time, before you ride the bike, check that the wheel is securely clamped.

The wheel quick release uses a cam action to clamp the bike’s wheel in place (see fig. 19). Because of its adjustable nature, it is critical that you understand how it works, how to use

it properly, and how much force you need to apply to secure the wheel.

!WARNING: The full force of the cam action is needed to clamp the wheel securely. Holding the nut with one hand and turning the lever like a wing nut with the other hand until everything is as tight as you can get it will not clamp the wheel safely in the dropouts.

a. Adjusting the quick release mechanism

The wheel hub is clamped in place by the force of the quick release cam pushing against one dropout and pulling the tension adjusting nut, by way of the skewer, against the other dropout. The amount of clamping force is controlled by the tension adjusting nut. Turning the tension adjusting nut clockwise while keeping the cam lever from rotating increases clamping force; turning it counterclockwise while keeping the cam lever from rotating reduces clamping force. Less than half a turn of the tension adjusting nut can make the difference between safe clamping force and unsafe clamping force.

b. Front Wheel Secondary Retention Devices

Most bicycles have front forks which utilize a secondary wheel retention device to keep the wheel from disengaging if its clamping mechanism is incorrectly adjusted. Secondary retention devices are not a substitute for correct wheel clamping.

Secondary retention devices fall into three basic categories (see Section 4.B figs. 12a, b &c):

(1)The clip-on type is a part which the manufacturer adds to the front wheel hub or front fork (fig. 12a).

(2)The integral type is molded, cast or machined into the outer faces of the front fork dropouts (fig. 12b).

(3)The washer type is a hat-shaped washer which fits into

28

Page 27 Page 29
Image 28
Page 27 Page 29
Contents For single-speed bicycles Read it before you take the first ride On your new bicycleGeneral Warning Special note for parentsContents Safety first Mechanical Safety CheckFirst Bike fitHandlebar and saddle alignment Make sure the saddle First rideSafety Riding SafetyWear safety gear appropriate to the kind of riding you plan Wet Weather Riding Night RidingBicycling in Traffic Downhill, Stunt or Competition BikingChanging Components or Adding Accessories FitStandover height Saddle positionHandlebar height and angle Brake reach TechBrakes Coaster Brake How the coaster brake works Adjusting your coaster brakeHand Brakes How hand brakes work Page Wheels Front Wheel Secondary Retention Devices Removing a Bolt‑On Front WheelInstalling a Bolt‑On Rear Wheel with Hand Brake Installing a Bolt‑On Front WheelRemoving a Bolt‑On Rear Wheel with Hand Brake Installing a Bolt‑On Rear Wheel with Coaster Brake PedalsWhich may cause you to lose control and fall Tires and Tubes Service Tire ValvesService Intervals Before every ride Mechanical Safety CheckIf your bicycle sustains an impact Appendix a LessonsDriveway Rideout Turning Without WarningFollowing the Leader SummaryAppendix B Page Appendix C Installing a Quick Release Front Wheel Removing a Quick Release Rear Wheel Seatpost Quick Release Raleigh America, Inc. Bicycle Limited Warranty
Top Page Image Contents