38 |
|
|
| 8 |
|
1 |
|
|
|
| 39 |
A |
| B |
| 58 |
|
|
| 58 |
| 30 | 30 |
|
|
4)Thread the right pedal (39) onto the right side of the crank (8) as shown. Tighten the pedal securely. Select the right pedal strap which has “R” marked on the bottom side of the strap. Snap the three hole end onto the inside edge of the right pedal (39). Snap the other three hole end onto the outside edge of the right pedal (39). Select adjustment holes which allow your foot to be easily removed from the pedals. Repeat with the left pedal and strap.
5)Insert the sensor wire (packed with tension con- troller) from the top of the handlebar post (75). Connect the sensor wire to the one on the main frame, and insert the sensor wire up into the handle- bar post.
Fix the handlebar post (75) onto the main frame (1) with screws (49) and arc washers (36).
6) Install the tension controller (30).
Step 1: Put the tension controller’s cable end into the spring hook.
Step 2: Pull and force the cable into the gap of the plate.
Step 3: Insert the tension controller into the “A” hole of handlebar post and attach it with the screw (65) attathed
7)Connect the sensor wire to the computer (33) and fix it on the top of the handlebar post by the screws (57) attached.
6