8. There is a large hole in the rear of the display console (#6) through which you can see a 10-pin connector and a 4-pin connector. These correspond to the matching connectors on the wire harness protruding from the top of the handlebar.
Model C7i Only: Properly align the locking tabs of the 16-PIN CONNECTOR (16P) on the WIRE HARNESS with the 16-PIN CONNECTOR on the back of the DISPLAY CONSOLE, then snap them together. Next, align the locking tabs of the 3-PIN CONNECTOR (3P) on the WIRE HARNESS with the 3-PIN on the back of the DISPLAY CONSOLE and plug them together until they SNAP into place.
Model C9i Only: Properly align the locking tabs of the 10-PIN CONNECTOR (10P) on the WIRE HARNESS with the 10-PIN CONNECTOR on the back of the DISPLAY CONSOLE, then snap them together. Next, align the locking tabs of the 4-PIN CONNECTOR (4P) on the WIRE HARNESS with the 4-PIN on the back of the DISPLAY CONSOLE and plug them together until they SNAP into place.
9. Feed the WIRE HARNESS back into the HANDLEBAR TUBE.
Attach the DISPLAY CONSOLE (#6) to the HANDLEBAR ASSEMBLY using the four CONSOLE SCREWS (#2) and a Phillips screwdriver. Tighten the four SCREWS in a crisscross pattern.
CAUTION!: BE CAREFUL NOT TO OVERTIGHTEN
THE SCREWS.
10. To install the 9-VOLT ALKALINE BATTERY (#8) found in the parts bag use a Phillips screwdriver to remove the screw from the back door. Gently pull the BATTERY WIRES from the back of the DISPLAY CONSOLE and connect them to the 9-VOLT ALKALINE BATTERY. Carefully, tuck the BATTERY WIRES back into the DISPLAY CONSOLE and set the BATTERY in place.
Re-install the BATTERY DOOR by inserting the bottom tab of the BATTERY DOOR into the corresponding slot in the DISPLAY CONSOLE. Push the DOOR into place and tighten the screw with a Phillips screwdriver.
CAUTION!: BE CAREFUL NOT TO OVER TIGHTEN THE SCREW
11. After placing the Lifecycle exercise bike in the intended location for use, check the stability of the bike.
If the bike is not level, rotate the FOOT in the STABILIZER BAR that appears to be higher until the Lifecycle is level.
Secure the position of the FOOT by tightening the LOCKNUT with the enclosed wrench.
10P 
16P
FOOT