3.Indicate the length (l) you want to cut on the seat tube with a marker pen.
4.Slide the Spark Cutting Tool on the seat tube of Spark until the line of the marker is visible in the slot on the tool that will guide your saw blade.
5.Fix the two 5mm bolts with a 4mm Allen key with a tightening torque of 6 Nm (53
6. Take a saw with a blade for cutting metal. Please only use a 10D/24T teeth blade to make sure not to damage the carbon tube
7.Cut the tube, remove the tool and take sandpaper to smoothen the edges of the cutting area.
8.Remount the seat clamp in its middle adjustment position (15mm over the top of the seat tube), fix the
2M5 screws of the seat clamp (4mm Allen key) with a tightening torque of 5Nm (44
REPLACEABLE DROPOUT
On Spark bikes of model year 07 you can replace the rear derailleur hanger.
In case the replaceable hanger is damaged by a crash or accident you can order at your local Scott dealer the replacement part with Scott article number 206473
PIVOT MAINTENANCE:
The pivot and bearings on SCOTT Spark are extremely easy to maintain.
An external treatment with a grease spray after every bike wash is all you have to do. We do not recommend heavy grease sprays since these will leave a film on the parts which is difficult to remove. We recommend the same for the chain also.
If you have to change the bearings you can order them included in a service kit at your local SCOTT dealer or buy them with international parts number as shown above in the specs list in a hardware store.
In case of a change of the bearings or of the rear swin- garm you should contact your local SCOTT dealer as you need special tools for disassembly and assembly
…
ENGLISH FRONT FORK
CHANGE OF FRONT FORK
For the set up of the front fork please use the fork specific manual attached to the bike.
We recommend using front forks with a travel of 100mm, as this will not influence the geometry and alter hand- ling of the bike.
DEUTSCH
FRANÇAIS
| OWNER’S MANUAL 2007 |
|
16 | 17 |