Impex TT-320 manual Assembly Instruction

Page 7

ASSEMBLY INSTRUCTION

Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen Wrench.

NOTE: It is strongly recommended two or more people assembling this machine to avoid possible injury.

Caution: Children must NOT use the equipment until it’s properly installed.

STEP 1 (See Diagram 1)

A.) Place the two Base Stabilizers (#2) on a flat surface. Attach one end of a Main Frame (#1) to a Base Stabilizer from the top. Attach one end of Cross Brace (#3) to the Base Stabilizer from the bottom. Secure them together with two M10 x 3 3/8” Hex Bolts (#20), four Ø ¾” Bent Washers (#26), and two M10 Aircraft Nuts (#28). Do not tighten the Nuts and Bolts yet.

B.) Repeat the same procedure to install the other Main Frame to the other Base Stabilizer.

C.) Place the Swing Base (#7) in between the two Main Frames (#1). Align the holes and secure them together with two M10 x 3 3/8” Hex Bolts (#20), four Ø ¾” Bent Washers (#26), and two M10 Aircraft Nuts (#28).

D.) Securely tighten all Nuts and Bolts.

E.) Attach the Cable Strap (#19) and the ring on the L-shaped Lock Pin (#18) to the small bracket on the Cross Brace (#3). Secure them with one M10 x 1” Allen Bolt (#22) and M10 Aircraft Nut (#28).

6

Image 7
Contents Gym Dandy Before YOU Begin Table of ContentsPage Care and Maintenance Important Safety NoticePage Hardware Pack Assembly Instruction Diagram Diagram Diagram See Diagram Page Parts list Operation Tips Impex INC