ParaBody 837101 manual Weight Stack Attachmentassembly Instructions

o

RemoveLIT BARWELDMENTfrom the HIGHPULLEYCABLE,and set aside. Loosen and remove the

three (3) 3-1/2 X 1 IN. PULLEYSfrom the BOOMWELDMENTDetach. HIGHPULLEYCABLEfrom the CARRL4GEWELDMENTand remove.

Loosen and remove BOOMWELDMENTfrom the FRONTand REAR UPRIGHTWELDMENT.Remove

the 2 IN. SQ. ENDCAPfrom the top of the REARUPRIGHTWELDMENTRemove. the CARRIAGE WELDMENTfrom the REAR UPRIGHT WELDMENT.

Insert the 1-3/4 SO. X 18-1/4 IN. TUBEinto the top of the REARUPRIGHTWP_ZDMENTas shown in ' (VIEWB), then SECURELYre-assemble the BOOMWELDMENTto the R,EAR UPRIGHT WELDMENTas shown.

Route CABLE(6577701) through the front slot and downto the rear slot of the BOOMWELDMENTRe.- assemble two (2) of the three (3) 3-1/2 X 1 IN. PULLEYSto BOOMWELDMENTasshownon the

(CABLE ROUTING DIAGRAM). (NOTE: MAKESURE CABLE IS THEGROOVE OF T HE

PULLEYS). SECURELYre-assemble the BOOMWELDMENTto the FRONTUPRIGHTWELD3tENT.

SECURELYassemble the PULLEYHOUSINGWELDMENTto the 1-3/4 SO. X 18-1/4 IN. TUBE as shoxvn in (VIEWB)

Slide one (1) 2 IN. SQ. COVERCAPover the end of the WEIGHTSTACKBASEWELDMENT,then SECURELYassemble it to the BASE WELDMENTasshown in (VIEW A) (NOTE: THE PULLEY CABLE MUST BE ASSEMBLED EXACTLY THE WAY SHOWN TO ENSURE PROPER FUNCTION)

Insert the GUIDERODSinto the holes of the WEIGHTSTACKBASEWELD?~4ENTas shown, and

allow them to tilt back. (NOTE: LUBRICATEGUIDE RODSWITH A SILICON OR TEFLON SPRAY THAT IS AVAILABLEAT MOST HARDWAR~STORES). Slide two (2) WEIGHT STACKCUSHIONSdown over the GUIDERODSas shown.

SECURELYassemble the WEIGHTSTACKSHAFTto the HEADPLATEas .,;hown on drawing. Also insert the WEIGHTPLATEBUSHINGSinto the WEIGHTPLATESas shown in (DETAILC).

3

12/01/95