Fisher-Price J5970 instruction sheet Press Here, Grooves Peg Top View Back View

Assembly

9

Wall

Rim

Peg

Backboard

Fisher-Price®

Logo

4

Groove

5

Upper Post

6

Base

11

4

5

6

Lower Post

Rib

Groove

•Lean the rim against a wall for support.

•Locate the pegs on each side of the rim and the grooves on the backboard.

•Position the backboard with the Fisher-Price®logo facing up.

•Place your foot on the base to hold it steady and slide

the backboard onto the upper post at an angle, as far as it will go.

Note: There should be no gap between the upper post and the backboard.

• Move the assembly away from the wall.

	PULL HERE
	Fisher-Price
	PRESS HERE
	Grooves
10	Peg	Peg
	Top View
	Back View

•Move to the side of the assembly.

•Place your foot on the base to hold it steady.

•Press down firmly on the lower backboard while rotating the backboard up.

•When properly assembled, the pegs on the upper post rest in the grooves in the backboard, as shown.

Note: The height of the rim is three feet (1 m) as assembled.

IMPORTANT! Assembly of the lower post to the base is a permanent assembly.

•Align the rib on the bottom of the lower post with the groove in the opening in the base.

Hint: For easier assembly, apply a small amount of liquid soap around the bottom of the post. If assembling indoors, place a tarp under the base to protect the floor surface.

•Insert the lower post into the opening and push down, using a circular motion, until it snaps into place.

	Collar
	Peg
	Lever
	Hole
12	Opening
	Lower
	Post

Note: The collar may already be factory assembled.

•Align the lever on the side of the collar with the opening in the top of the lower post.

•Fit the collar onto the lower post, making sure the peg on each side of the collar snaps into the hole on each side of the post.

5