1.Before beginning assembly, be sure that you have read and understand the information on the previous page.
Press a 38mm x 38mm Inner Cap (16) into the end of the Frame (1). Press Two 50mm Round Outer Caps (9) onto the Adjustment Leg (3). Press a 38mm x 50mm Inner Cap (8) into the end of the Adjustment Leg.
Align the indicated holes in the Frame (1) and the Adjustment Leg (3). Attach the Adjustment Leg to the Frame with two Lock Pins (11).
2.Align the indicated holes. Attach the Pivot Leg (2) to the Frame (1) with the M10 x 68mm Bolt (14) and the M10 Nylon Locknut (13).
Secure the Pivot Leg (2) by inserting the “L” Pin (15) through the indicated hole in the Pivot Leg and the corresponding hole in the Frame (1).
Press Two 50mm Round Outer Caps (9) onto the Pivot Leg (2).
3.Press 3/4” Round Inner Caps (7) into the ends of both Pad Tubes (10).
Insert the Pad Tubes (10) through the Adjustment Leg (3).
Slide Foam Pads (6) onto the ends of both Pad Tubes (10).
4.Attach the Bench (12) to the Frame (1) with two M6 x 48mm Bolts (4) and two M6 x 16mm Bolts (5).
1 |
| 8 |
|
| |
| Align these | 3 |
| Holes | 11 |
|
| |
| 1 |
|
16 | 9 |
|
|
| |
2 | 1 |
|
|
| Align these |
|
| Holes |
| 13 |
|
|
| 15 |
| 2 | 14 |
|
| |
| 9 |
|
3 |
|
|
| 6 | 3 |
| 7 | |
| 10 |
|
|
| 7 |
|
| 6 |
4 |
|
|
| 12 |
|
| 1 |
|
| 5 | 4 |
5