JVC XL-FZ700BK manual Compu Link connection, To install the batteries in the remote control unit

Before using for the first time

To install the batteries in the remote control unit

Before operating the remote control unit, install two batteries.

1 While pushing the tab of the rear cover, remove the rear cover from the remote control upwardly.

Before using for the first time	2 Install batteries. Be sure that the batteries are
	installed with correct polarity, (+) and (–).

3 While aligning the end of the rear cover with the remote control, assemble the rear cover on the remote control by pushing it downwardly.

NOTES

Incorrect use of batteries can cause corrosion or damage. Note the following points to lengthen battery life.

•Install batteries observing the correct polarity, (+) and (–).

•Do not use new and old batteries simultaneously.

•Batteries with similar shapes may have different voltage ratings. Be sure to use the correct batteries.

•Remove batteries from the remote control unit if it will not be used for a long period of time.

•Do not expose batteries to heat or flame.

Battery replacement

Service life of batteries depends on the condition of use; standard life is about one year. When the batteries become weak, the operating distance of the remote control unit becomes short. If this happens, replace the batteries R6P(SUM-3)/AA(15F) with new ones.

NOTE

•The lower the temperature, the shorter the battery life.

COMPU LINK connection

JVC’s COMPU LINK Remote Control System provides unified control over system components connected with COMPU LINK. Connecting JVC audio components with the COMPU LINK jacks automatically controls relative operations between components and facilitates various operations. With the COMPU LINK connection to an amplifier or receiver, you can operate XL-FZ700BK with the amplifier or receiver’s remote control unit. Synchronized recording is also available with this feature.

Connecting the COMPU LINK cord

The COMPU LINK-3 (SYNCHRO) jacks are used to output and input the control signal for the COMPU LINK remote control system.

COMPU LINK-compatible products are provided with the jacks marked COMPU LINK-1, COMPU LINK-2 or COMPU LINK-3, referring to the COMPU LINK version. XL- FZ700BK is equipped with COMPU LINK-3. You can connect XL-FZ700BK also to a component with lower COMPU LINK versions. But, in that case, only the lower versions’ features will be available.

Plug the supplied COMPU LINK cord into the COMPU LINK-3 (SYNCHRO) jack on the rear panel of XL-FZ700BK. Plug the other end into the COMPU LINK jack of the other component. If there are two COMPU LINK jacks, plug it into either of them.

Connect to the COMPU LINK-3 (SYNCHRO) jack of another component equipped with the Compu Link remote control system.

			Rear panel of this unit
DIGITALOUT	OUTPUT		COMPU(SYNCHRO)LINK-3	ACIN
OPTICAL	RIGHT	LEFT
COMPU LINK cord*

Amplifier or receiver Cassette deck Turntable

* Only one COMPU LINK cord is supplied.

6