Weider WESY68630 user manual Upper Cable Adjustment

Page 14

UPPER CABLE ADJUSTMENT

After completing the assembly of the resistance system, the tension on the upper cable (B) will need to be adjusted. Also, the upper cable can stretch slightly when it is first used. When this occurs, the upper cable ten- sion will need to be readjusted. Follow the steps below to adjust the upper cable tension.

1.Connect the two Tension Gauges (107, 108) together using the magnet.

2.Plug in the resistance system as described in PLUGGING IN THE RESISTANCE SYSTEM on page 17. Use the Console (not shown) to adjust the resistance setting of the system to the highest setting, as described in ADJUSTING THE RESIS- TANCE on page 16.

Squeeze the upper cable (B) together near a Large Pulley (17). Hook the ends of the Tension Gauges (107, 108) around the upper cable as shown. Do not hook the ends of the Tension

Gauges around the Tether (61); which is attached to the back of the Pulley Bracket (10).

Slide the Tension Gauges (107, 108) next to the Large Pulley (17) as shown in the inset drawing.

3.Locate the 3/8” x 38mm Tension Screw (106) on each end of the Resistance Bar (9). Alternately tighten each Screw one turn at a time until the two Tension Gauges (107, 108) are pulled apart by the upper cable (B).

The upper cable tension is now properly adjusted.

1

 

 

 

 

 

107

 

 

 

 

 

Magnet

 

 

 

108

 

 

 

2

10

 

 

 

 

 

 

 

 

107

 

 

 

 

 

B

 

 

17

108

61

 

 

 

B

 

 

107

 

 

17

108

B

3

 

 

 

 

 

 

9

 

 

106

 

 

 

 

 

 

107

 

 

 

 

108

 

 

 

 

B

 

 

14

Image 14
Contents Customer HOT Line QUESTIONS?Model No. WESY68630 Serial No Table of Contents Keep hands and fingers clear of this area Important Precautions Assembled Dimensions Before YOU BeginAttach the other Wheel 21 to the Base 1 in the same manner AssemblyMake Things Easier for Yourself Page Tighten the 1/2 Nylon Jamnut Connector should slide easily into the sockNylon Jamnut 78. Do not tighten the Jamnut Yet 105 Do not tighten the Locknut yet Tighten the Bolt yet Bolt yet106 Pulley is above the Leg Lever Cable Repeat this step with the Leg LeverUpper Cable Adjustment Attaching the High Pulleys AdjustmentsAdjusting the Seat Attaching the LEG Lever Attaching the AccessoriesAdjusting the Resistance Plugging in the Resistance System Adjusting the BackrestStoring the Resistance System Cable Diagram Upper Cable BTroubleshooting Cleaning the BAR GuidesExercise Guidelines Staying Motivated Muscle ChartCooling Down Aerobic Exercise Exercise Weight Sets RepsDate Thursday Aerobic Exercise DateMonday Part Identification Chart Part LIST-Model No. WESY68630 Qty DescriptionExploded DRAWING-Model No. WESY68630 Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty