Washer & Dryer Pedestal Kit
This kit is intended to be installed by persons having electrical and mechanical training and a level of knowledge considered acceptable in the appliance repair trade.
This kit contains:
........
:::_:_ : I%:;¸_,_ |
| 0 |
::3Rg I_k | washers | |
:Frant | mounting |
|
brackets
m
'10_6 X 1" screws
Tools needed:
Level
9/16" open end wrench
2# Phillips screwdriver Small flat blade screwdriver
Washer Installation
1.Remove the pedestal, installation hardware and instructions from the shipping carton.
2.Carefully lay the washer on it's back.
3.Remove the four (4) leveling legs from the washer base and discard.
4.If the washer has rollers, remove the four (4) screws securing the rollers to the base and discard the rollers.
5.Install the four (4) leveling legs (supplied with the kit) fully into the pedestal.
6.Position the pedestal at the bottom of the washer base and align the pedestal mounting holes with the threaded leg holes on the washer.
7.Attach the pedestal to the washer using the four (4) 3/8" X 1" bolts, 3/8" fiat washers and 3/8" lock washers.
8.Tighten the bolts with a 9/16" wrench or socket.
9.Carefully raise the washer/pedestal assembly to the upright position.
10.Reconnect the washer to the existing facilities and/or refer to the installation instructions that came with the washer for proper installation.
134176300 8/02