Start and Programmes
GB
The Controls
●PROGRAMMES knob
!Warning, if after pressing the start button, the programmes knob position is changed, the new position will NOT change the programme selected.
To change a selected programme, press the Start/Pause button 
, the light flashes Amber to indicate the programme is paused. Select the new programme and any options required, the light will then flash green. Press the Start/Pause button 
again and the new programme will start.
●OPTION buttons / lights
These buttons are used to customise the selected programme to your requirements. Not all options are available for all programmes (see Start and Programmes). If an option is not available and you press the button, the buzzer will beep three times. If the option is available there will be one beep and the option light next to the button lights to confirm the selection.
Progress ( 
Drying, 
Cool Tumble, End) / Delay (3hr 6hr 9hr) Lights
When the light next to the delay button is on, these lights flash to indicate the delay time selected. During other programmes they indicate the progress of the dryer, each one comes on as the corresponding phase starts.
Time Delay
The start of some programmes (see Start and Programmes) can be delayed for up to 9 hours in 3hr steps.
When a delayed start is in progress the light next to the delay button will be on and the selected delay period light will flash (after the start button has been pressed). To set a delayed start, press the Delay Timer button, and the light next to the button will come on together with the 3hr delay light. Pressing the button again will advance the delay setting to 6hr, the 3hr light goes out and the 6hr light is on. Each time you press the button the delay setting advances 3 hours, as indicated by the corresponding light. If the 9hr light is on, pressing the button again will cancel the delay. Holding in the On/Off button will also cancel.
Crease Care
The
The
High Heat
Press this button and a high heat setting is selected and the light next to the button comes on. If the light alongside the button is on then pressing the button selects a low heat setting and the light goes out.
Not all programmes allow you to change this setting.
Empty Water Light / Container
(If you have plumbed your dryer to a drain this light can be ignored, as there is no need to empty the water container).
When this light is on (not flashing) it reminds you to empty the water container.
If the water container fills during a programme, the heater turns off and the dryer does a period of Cool Tumble then the light flashes and the buzzer sounds. You must empty the water container and restart the dryer or the clothes will not dry. After
To avoid this always empty the water container each time you use the dryer (see Maintenance).
●Door Opening
Opening the door (or pressing the Start/Pause button) during a programme will stop the dryer and have the following effects:
Note: The Start/Pause light flashes Amber during the Heat & Enjoy programme and during the Post Care phase of a programme.
●The Start/Pause light flashes Amber.
●During a delay phase the delay will continue to count down. The Start/Pause button must be pressed to resume the delay programme.
One of the delay lights will flash to show the current delay setting.
●The Start/Pause button must be pressed to resume the programme. The progress lights will change to show the current status and the Start/Pause light will stop flashing and turn green.
●During the Post Creasecare phase of a drying programme, the programme will finish. Pressing the Start/Pause button will
●Changing the programmes knob will select a new
programme and the Start/Pause light will flash
green. You can use this to select the 
Refresh programme to cool the clothes, if you find them dry enough. Press the Start/Pause button to begin a new programme.
●Note
If you have a power cut, switch off the power or remove the plug, press the Start/Pause button and the programme will resume.
10