Dryer Description
GB
To open the door
Press and release the front panel in position shoiwn
Condenser Unit (cover open)
Control panel
OPTION
Buttons
The features
Water container Rating plate
Model &
Serial numbers
|
|
|
|
|
|
|
|
|
|
| Air intake |
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
| |
Condenser cover |
|
|
|
|
|
|
|
| grille | ||
|
| Filter |
|
| |||||||
Condenser cover handle |
|
|
| ||||||||
|
|
|
|
|
|
| |||||
|
| (Pull to open) |
|
|
|
|
|
|
| ||
|
| START/CANCEL |
|
|
|
| |||||
|
|
|
|
| |||||||
Empty Water |
| Indicator |
| Button |
|
| On/Off | ||||
|
| ||||||||||
Light |
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
| Light | ||||
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Drying Guide
Option
Lights
Progress or Delay
Lights
PROGRAMMES
Knob
ON/OFF
Button
The START/CANCEL button starts a selected programme. When you press this button there will be one beep and the progress lights will flash to confirm the action. If you have not set a programme, the buzzer will beep four times. When a programme is running, holding this button in cancels the programme and stops the dryer (see Start and Programmes).
The OPTION buttons select available options for your selected programme (see Start and Programmes).
The Option lights indicate that the option has been selected by the button to the left of the appropriate light.
The Drying Guide allows you to consult a user friendly table of fabric types and load capacities.
The Empty Water light signals that the water container should be emptied. When it is flashing it indicates that the container is full.
The light will take a few seconds to go out after replacing the empty container, the dryer must be
running for this to happen (see The Controls).
Note: If the water container fills and the light flashes, the heat is turned off and your laundry will not dry.
The On/Off indicator light 
signals that your dryer is in use or ready to select a programme. If this light flashes it indicates there is a fault (see Troubleshooting).
The ON/OFF button 
: If the dryer is running and this button is pressed, the dryer stops. Press again, the dryer restarts.
The Progress or Delay lights show you the status of the programme, or the delay time when they flash. During a delayed start the lights will flash to show the delay selected. When (not flashing) they show each stage of the programme by the corresponding light turning on (see Start and Programmes).
The PROGRAMMES knob sets the programme: rotate it until the indicator is pointing to the programme you want to select (see Start and Programmes).
6