Hotpoint CTD00 manual Condenser Unit

Important Information

Condenser Unit...

!You MUST clean the fluff from the condenser EVERY month.

GB

Information Important

STEP 1.

Open the condenser cover

-hold the handle and pull towards you.

STEP 2.

Remove the condenser by rotating the 3 clips then pulling the condenser towards you.

(There may be some water in the tubes, this is normal).

STEP 3.

Flush the condenser, from the rear with water, to remove any fluff deposits.

STEP 4.

Refit the condenser unit

-ensure that the unit is pushed in fully, all 3 clips are re-secured and the positiong arrows on the front of the condenser are pointing upwards.

Installation

Description

Programmes Start and

Rotate 3 clips

●Check that:

-The positioning arrows are pointing upwards.

-The 3 clips are re-secured back into their ‘lock’ position.

Laundry
Suggestions	Warnings

!Failure to clean the condenser could cause premature failure of your dryer.

and

and Maintenance Care

Troubleshooting

Service

3