Hotpoint AQC9 BF5 Maintenance and Care, Clean the filter after each cycle, Cleaning the drum

Maintenance and Care

GB	Switching off the electricity	Empty the Water Container after each cycle
	! Unplug the dryer when not using it, when cleaning it, and	Pull the container out of the dryer and empty it into a sink or
		other suitable drain. Replace container securely.
	during maintenance activities.	Always check and empty the container before you start a new
	Clean the filter after each cycle	drying programme.
		Cleaning the Condenser Unit
	The filter is an important part of your dryer: it accumulates
	lint and fluff that is formed while drying.	•	Periodically (every month) remove Condenser unit and
	When finished drying, clean the filter by rinsing it under		clean any build up of fluff from between the plates by
	running water or with your vacuum cleaner. Should the		rinsing it under the tap with cold water. This should be
	filter become clogged up, the airflow inside the dryer will be		done with cold water from the rear of the condenser.
	seriously compromised: drying times lengthen and you will	To remove condenser :
	consume more energy. It may also damage your dryer.	1. Unplug the dryer and open the door.
	The filter is found in front of the dryer trim (see diagram).	2. Pull open the condenser cover (see diagram), release
	Removing the filter:		the three catches by turning 90° counter clockwise then pull
	1. Pull the plastic grip of the		on the grip and remove from dryer.
	filter upwards (see diagram).	3. Clean the surface of the seals and replace with the
	2. Open the filter by		arrows pointing upwards making sure that the catches
	depressing the clip.		have been secured.
	3. Clean the lint from the	Cleaning the dryer
	inside of the filter, and
	replace it correctly. Ensure	•	External parts in metal or plastic and rubber parts can
	the filter is fully located flush		be cleaned with a damp cloth.
	into the tumble dryer trim.	•	Periodically (every 6 months) vacuum the front Air intake grille
			and Vents at the rear of the dryer, to remove any build up of
			fluff, lint or dust. Also to remove accumulation of fluff from the
	! Do not use dryer without replacing the filter.		front of condenser and filter areas, clean occasionally with a
			vacuum cleaner.
	Check the drum after each cycle	! Do not use solvents or abrasives.
		! Your dryer uses special bearing components which do not
	Turn the drum manually in order to remove small items
			need lubrication.
	(handkerchiefs) that could have been left behind.	!
			Have your dryer checked regularly by authorized technicians
	Cleaning the drum		to ensure electrical and mechanical safety (see Service).

!Do not use abrasives, steel wool or stainless steel cleaning agents to clean the drum.

A coloured film may start to appear on the stainless steel drum, this may be caused by a combination of water and, or cleaning agents such as fabric conditioner from the wash. This coloured film will not affect the dryer performance.

Filter

Tap

Rear

Water Contaniner

Condenser

Unit

Condenser	Air Intake
Unit

Front

Catches

Handle Condenser Cover

16