Dryer Description
To open the door
The features
GB
Press and release the front panel in position shown
Water container
Door latch
Rating plate
Model & Serial numbers
Door catch
Installation |
|
Description |
| Air intake | |
Condenser cover | grille | |
Filter | ||
Condenser cover handle | ||
| ||
(Pull to open) |
|
Control panel
|
| START/CANCEL |
| On/Off | |
Time and Icon |
| Button |
| Light | |
| |||||
|
|
|
| ON/OFF | |
Display unit |
|
|
|
| |
|
|
|
| Button | |
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
OPTION |
| PROGRAMME Selection |
Buttons |
| Buttons |
|
Programmes | Start and |
|
|
Laundry |
|
|
|
Suggestions | Warningsand |
The START/CANCEL button starts a selected programme. When you press this button there will be one short beep and the progress icons will flash on/off to confirm the action. If you have not set a programme, the buzzer will beep four times. When a programme is running, holding this button in gives one long beep and cancels the programme and stops the dryer (see Start and Programmes).
The OPTION buttons/icons: these buttons select available options for your selected programme (see The Controls). The icons indicate that the option has been selected.
The Empty Water icon 
signals that the water container should be emptied. When it is flashing it indicates that the container is full.
The light will take a few seconds to go out after replacing the empty container, the dryer must be running for this to happen (see The Controls).
The Clean Filter icon 
reminds you to clean the filter every time you use the dryer (see Maintenance).
The On/Off indicator light 
signals that your dryer is in use or ready to select a programme.
The ON/OFF button 
: If the dryer is running and this button is pressed, the dryer stops. Press again, the dryer restarts. If you have not opened the door, press START button to continue.
The Progress icons :
show you the status of the programme. They show each stage of the programme by the corresponding icon turning on (see Start and Programmes).
The PROGRAMME Selection buttons set the programme: press the button corresponding with the programme you want to select (see Start and Programmes).
Maintenance Care |
and |
|
Troubleshooting |
|
Service |
3