Hotpoint V3D00 manual How to use your dryer

Page 7

How to use your dryer

1.Plug in, switch on electricity.

WARNING: WHEN SWITCHING ON OR OFF, PLEASE ENSURE THAT YOUR HANDS ARE DRY

2.Sort your laun- dry (see section “Sorting Your Laundry”)

3.Open the door. Check that the fluff filter is clean (see section How to remove and clean the fluff filter).

4.Load the dryer placing the clothes carefully in the drum, pushing them well towards the back and away from the door seal. Close the door.

5.Select the relevant heat setting (see section “Sorting your Laundry”).

Push IN for high heat, for cottons, linens and synthetics.

Low setting - button OUT for acrylics and acrylic mixtures.

Button OUT LOW HEAT

Button IN

HIGH HEAT

6.Turn the Timer clock- wise to select the required drying time. (See Section “The Controls”.)

The dryer will start

7.When finished open the door and take out the laundry.

Clean and replace the fluff filter.

8.Switch off electricity and remove plug from socket.

WARNING: WHEN SWITCHING ON OR OFF, PLEASE ENSURE THAT YOUR HANDS ARE DRY

Never switch the dryer off with a hot load in the drum.

You must terminate every programme with the Cool Tumble Phase.

7

Image 7
Contents Instructions Contents For your safety Close the door Ventilation. see, Where to put and vent your dryerSymbol Buy genuine accessories and sparesElectrical Requirements Where to put and vent your dryer How to use your dryer Maximum load size Typical load Sorting your laundryItems not suitable for tumble drying Wash Care LabelsItems requiring special attention Controls Never wind the Timer Control anti-clockwiseDoor Release Heat Selection Mains Light if fitted Guide to Drying Times To remove the filter When finished After each load As necessary LubricationSwitch off electricity and remove plug Caring for your Dryer‘It is taking a long time to dry’ Problem Check these things firstProblem If something goes wrongIf it still won’t work Key Contacts