Groupe SEB USA - T-FAL PROTECT TURBO manual When the RED Light Water Tank Empty Comes on

Page 6

7- WHEN THE RED LIGHT “WATER TANK EMPTY” COMES ON

There is no more steam.The removable water tank is empty (12).

1.Raise the 2 parts of the hood over the iron until the protection system locks into place (audible click) (13).

2.Grasp the handles of the removable tank and pull horizontally to remove it; fill with water.

3.Replace and push it firmly into place.

4.Press the release button for the hood and fold it down over the tank (14).

12

CLICK

13

14

8- VERTICAL STEAM IRONING

1.Set the iron temperature control slide and the steam output control dial (located on the control panel) to the MAX position.

2.Hang the garment on a coat hanger and hold the fabric slightly taut with one hand. As steam is very hot, never attempt to remove creases from a garment while it is being worn, always hang garment on a coat hanger.

3.Holding the iron in a vertical position, tilted slightly forwards, press repeatedly on the steam control button (under the iron handle) moving the iron from top to bottom (15).

Recommendations : for fabrics other than linen or cotton, hold

the iron a few centimetres from the garment to avoid burning the fabric.

15

9- TURBO STEAM FUNCTION (depending on the model)

Press 2 or 3 times on the turbo steam button to obtain a more powerful burst of steam (16):

 

• for ironing thicker fabrics,

 

• to eliminate creases,

 

• for powerful vertical steaming.

 

Be careful : use the turbo steam function very carefully because of the

 

exceptional power of steam that may cause burns.

 

NOTE : continuous use of the turbo steam function will begin to cool the iron and may

 

cause water to drip from the iron. If this occcurs, stop using the turbo steam function

 

and allow the iron thermostat to reach temperature again (thermostat light will come

16

on and go off) before using this function again.

 

10- MAINTAINING YOUR STEAM GENERATOR

Before cleaning, ensure that your steam generator is unplugged and that the soleplate and the iron rest have cooled down.

• Do not use detergent or descaling products for cleaning the soleplate or the base-unit.

• Never hold the iron or the base unit under the tap.

• Do not place the iron on a metal rest as this could damage it.

Place it on the iron-rest on the base unit : it has non-slip pads and has been designed to withstand high temperatures.

1. Empty and rinse the removable water tank (17).

2. Regularly clean the soleplate with a damp, non-metallic washing up pad.

3. Clean the plastic parts of the appliance occasionally with a soft cloth.

17

Image 6
Contents Mod. Protect Mod. Protect Turbo English Understanding Your Steam GeneratorProtect Concept Safety System Protect ConceptUsing Your Steam Generator Preparing Your Steam GeneratorOperating the Control Panel Continuous green light steam is ready for useWhen the RED Light Water Tank Empty Comes on Vertical Steam IroningMaintaining Your Steam Generator To Rinse the Boiler Using Rinsing Accessory Orange Boiler Rinse Light FlashesSafety Recommendations Putting Your Steam Generator AwayEnvironment Protection First Is There a Problem ? Problems Possible causes Solutions