Groupe SEB USA - T-FAL PRO EXPRESS manual Using Your Steam Generator, Operating the Control Panel

Page 4

4- USING YOUR STEAM GENERATOR

1.Push the retaining clip forward to release the iron(6).

2.Completely unwind the power cord from its storage space before connecting to an earthed socket (7).

3.Press on the on / off switch (located on the side of the base unit) (a): the green light (located on the control panel) flashes and the boiler heats up (b).It will take around 2 minutes for steam to be produced which is indicated when the green “steam ready” light stops flashing (8).

6

7

(b)

(a)

8

The first time the appliance is used, there may be some fumes and smell but this is not harmful. They will not affect use and will disappear rapidly.

5- OPERATING THE CONTROL PANEL

• Flashing green light : the water is heating up in the boiler.

• “Restart” button:

• Continuous green light :

- to be pressed after each refill of the water tank

steam is ready for use.

to start ironing again (see paragraph 7),

• Continuous red light :

- to be held pressed after rinsing the boiler

the water tank is empty.

(see paragraph 11).

• Orange “boiler rinse” light flashes :

 

your boiler needs rinsing.

 

Note: the appliance must be cold (see section 11).

6- USING YOUR STEAM GENERATOR

• Place the iron's temperature control slide according to the type of fabric to

linen

lin

be ironed (see table + 9).

cotton coton

wool

laine

• The thermostat light comes on. Be careful ! The steam generator is ready

silk

soie

synthetic synth.

when the thermostat light goes out and when the green “steam ready” light

 

 

stays on.

 

 

• Adjust the steam output control dial (located on the control panel - 10).

 

9

While ironing, the light on top of the iron and the steam ready light turn on and off, according to

the heating needs without any disturbing the use.

To obtain steam, press on the steam control button on top of the iron handle and keep it pressed (11).The steam will stop when you release the button.

When starting, and regularly while it is being used, your steam generator's electric pump injects water into the boiler. It makes a noise but this is quite normal.You may also hear a clicking noise which is the steam valve opening.Again this is normal.

Always spray starch onto the reverse side of the fabric to be ironed.

10

11

Do not place the iron on a metal support.When taking a break from ironing, always place the iron on the iron rest plate of the unit. It is equipped with non-slip pads and has been designed to withstand high temperatures.

Image 4
Contents Mod. PRO Express Mod. PRO Express Turbo Understanding Your Steam Generator Control panelPreparing Your Steam Generator Locking System for Retaining the Iron on the BaseLock Using Your Steam Generator Operating the Control PanelWhen the RED Light Water Tank Empty Comes on Vertical Steam IroningMaintaining Your Steam Generator To Rinse the Boiler Using Rinsing AccessoryOrange Boiler Rinse Light Flashes 1I. to Rinse the Boiler Without the Rinsing Accessory Putting Your Steam Generator AwayCheck that the generator is cold and unplugged Still hotSafety Recommendations Environment Protection FirstProblems Possible Causes Solutions Is There a Problem ?Helpline