Hotpoint TCL770 manual Condenser Unit

Page 3

Important Information

Condenser Unit...

!You MUST clean the fluff from the condenser EVERY month.

GB

Information

Important

STEP 1.

Open the condenser cover

-hold the handle and pull towards you.

STEP 2.

Remove the condenser by rotating the 3 clips then pulling the condenser towards you.

(There may be some water in the tubes, this is normal).

STEP 3.

Flush the condenser, from the rear with water, to remove any fluff deposits.

STEP 4.

Refit the condenser unit

-ensure that the unit is pushed in fully, all 3 clips are re-secured and the positiong arrows on the front of the condenser are pointing upwards.

Installation

 

Description

 

Programmes Start and

Rotate 3 clips

●Check that:

-The positioning arrows are pointing upwards.

-The 3 clips are re-secured back into their ‘lock’ position.

Laundry

 

 

 

Suggestions

Warnings

!Failure to clean the condenser could cause premature failure of your dryer.

and

 

and Maintenance Care

 

Troubleshooting

Service

3

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Tumble Dryer Instruction bookletPriming the Water Collection System Important InformationCondenser Unit Installation Control panel FeaturesDryer Description To open the doorFabric Start and ProgrammesChoosing a programme Easy Iron ProgrammeProgrammes Programme What it does How to set itControls Programmes knob Option buttons / lightsDoor Opening Typical weights LaundrySorting your laundry Drying times Special clothing itemsSaving energy and respecting the environment General safetyRecycling and disposal information Disposal of old electrical appliancesMaintenance and Care Problem Possible causes / Solution TroubleshootingComparative Programmes ServiceBefore calling the Service Centre What to tell the Service CentrePage Key Contacts
Top Page Image Contents