Electrolux 76810 manual Not been removed Aging

Problem	Possible cause	Remedy
	The transit packaging has	Removing the transit pack-
The washing machine	not been removed.	aging.
vibrates when operating	The screw feet not correctly	Adjust the feet as described
or is not stable.
		in the installation and con-
	adjusted.
		nection instructions.
Washing has not been	Only a few large items of	Always load the drum as full
		as possible. Mix large and
spun.	washing in the drum.
		small items.
	Screw connection on the in-	Screw the inlet hose on
	let hose is leaking.	tightly.
	Drain hose is leaking.	Replace drain hose.
Water is running out	Drain pump cover is not	Close the cover properly.
from under the washing	closed properly.
machine.	Washing was caught in the	Load washing carefully for
	door.	the next wash.
	Emergency drain hose is	Close off emergency drain
	leaking.	hose properly.
Wash water is foaming
excessively. At the end		Follow the manufacturer's
of the washing cycle,	Too much detergent has
		instructions exactly when
the spin stops. The	probably been used.
		measuring out detergent.
OVERDOSING indicator
lights up.
	Kink in drain hose.	Straighten the hose.
E20 appears.	Do not exceed the maxi-	Please contact customer
	mum pump height of 1m.	service.
The END indicator		Switch off the appliance.
flashes 2x, and an
acoustic signal sounds	Drain pump is blocked.	Disconnect the power plug.
2x.		Clean the drain pump. Re-
(Problems with water		move foreign bodies from
inflow.)		the pump housing.
	For sink spigot connections:	Clean the sink spigot.
	The sink spigot is blocked.
Fabric softener was not	Fabric softener insert in the	Clean the detergent drawer,
rinsed in, the compart-	compartment for condition-
		insert the fabric softener
ment w for condition-	ers is not correctly attached	insert firmly.
ers is full of water.	or is blocked.

20