Ofrecido por www.electromanuales.com
•The washing machine has stopped with water in the tub, at the end of a programme with the “Rinse Hold” or “Night Cycle”
option: this is indicated by a flashing zero. The
“Door” light will be lit and the door will be locked.
•The washing machine has completed the programme: this is indicated by a flashing zero. The zero will reappear when you switch the washing machine on, unless the previous programme has been erased by turning the programme selector dial to the “O” Off position. The “Door” light will be off and the door can be opened.
0
Important!
The first time you use the washing machine, when you switch it on, it may display a flashing zero and give an audible warning signal. This is due to the fact that the washing machine has performed a washing cycle during the manufacturer’s inspection tests, and this cycle has not been erased after its completion.
•Delay start, a time value indicated in hours and selected by means of the relevant button (max 23 hours).
The delay time is displayed for 3 seconds, then the duration of the selected programme reappears.
After you have pressed the “Start/Pause” button, the countdown begins, and the delay time value decreases by one unit every hour and then, when 2 hours remain, the time decreases in 30 minute intervals.
You can delay the start of the selected programme by up to 23 hours in one hour intervals.
•An incorrect option selection has been made: this is indicated by the message Err when a function incompatible with the current programme is selected.
The incorrect selection is also indicated by an audible warning signal.
•An alarm code indicates a fault in the machine operation (see the relevant chapter on page 20).
E20
8 “Delay Time” button
This button makes it possible to delay the starting of the programme selected from 30 min - 60 min - 90 min, 2 hours and then by 1 hour up to a maximum of 23 hours. The delay you have selected is shown on the display for about 3 seconds; afterwards, the duration of the programme reappears.
You must select this option after you have set the programme and before you press the “Start/Pause” button.
The time value shown on the display will decrease by one unit every hour.
8