Electrolux EIFLSS55I specifications Front Load Washer Specifications, Optional Accessories

Front Load Washers

EIFLS55I RR/MB/IW

Front Load Washer Specifications

•Product Weight – 237 Lbs.

•An electrical supply with grounded three-prong receptacle is required. The power supply circuit must be installed in accordance with current edition of National Electrical Code (ANSI/NFPA 70) and local codes & ordinances. (Do not use same circuit as dryer.)

•Voltage Rating – 120V/60Hz/15 Amps

•Amps @120 Volts = 12 Amps

•Connected Load (kW Rating) @120 Volts = 1.4kW

•Equipped with 120V 3-wire power supply cord, approx. 60" long.

•Always consult local and national electric & plumbing codes.

•To maximize detergent effectiveness, ambient temperature should never be below 60°F.

•Can be installed alone, with or without optional 15" drawer pedestal, or stacked beneath matching Electrolux Dryer, which requires installation of optional dryer stacking kit. (For installation details, refer to instructions included with optional pedestal or stacking kit or on web.)

•Can be built in with matching Electrolux Dryer in under-counter, recessed or closet installation. Installations requiring countertop and/or cabinetry will require custom building. (Refer to Built-In Installations on this page for cutout dimensions. For additional installation details, refer to Product Installation Guide on web.)

•Closet installation requires vented door with 2 unobstructed louvered openings, minimum 60 sq. in. each, located 3" from top and bottom of door. Full-length120 sq. in. opening also acceptable. Allow 1" clearance between door and fronts of units.

•Do NOT install in area exposed to dripping water or outdoor weather conditions, or where gasoline or other flammables, including automobiles, are kept or stored.

•Floor MUST be solid with 1" maximum slope. To ensure vibration or movement does not occur, reinforcement of floor may be necessary. Do NOT install on carpeted surface.

•Leveling legs supplied to level washer properly and reduce excessive noise and vibration.

•H/C water faucets MUST be installed within 42" of washer’s water inlet and MUST be 3/4" garden hose type, to connect to 48-1/2" inlet hoses.

•Water pressure MUST be between 30 and120 psi with NOT more than 10 psi pressure difference between hot and cold.

•Drain required with standpipe diameter of 1-1/4" min. and height of 24" min. /96" max. above floor, capable of eliminating 17 gallons per minute. Attached 59" drain hose can reach 79"-high standpipe.

Note: For planning purposes only. Refer to Product Installation Guide on the web at electroluxappliances.com for detailed instructions.

Optional Accessories

•Drawer Pedestals – Red Hot Red (PN# EPWD15RR),

Mediterranean Blue (PN# EPWD15MB), Island White (PN# EPWD15IW).

•Dryer Stacking Kit – (PN# STACKIT4X).

•Drain Hose Extension Kit – (PN# 137098000).

•Mobile Home Installation Kit – (PN# 137067200).

Electrolux Major Appliances, N.A.

USA • 10200 David Taylor Drive • Charlotte, NC 28262	• 1-877-4electrolux (1-877-435-3287) • electroluxappliances.com	High standards of quality at Electrolux Home Products, Inc. mean
		we are constantly working to improve our products. We reserve the right
CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • electroluxappliances.ca
		to change specifications or discontinue models without notice.
EIFLS55I 06/12	© 2012 Electrolux Home Products, Inc.