Electrolux LAVAMAT W 1050 manual Start/Pause

Operating Instructions

Problem	Possible cause	Remedy
		Pay attention to the maximum
Washing is heavily	Probably too much washing	load quantity (see Programme
		Tables). In the case of easy-
creased.	has been put in the drum.
		care fabrics, select the EASY
		IRON programme.
	The drain hose is kinked.	Remove the kink.
Washing is not	The maximum pump height	Contact your local Service
		Force Centre. For pumping
	(outlet height 1 m from
thoroughly spun,		heights over 1 m a conversion
	the base of the appliance)
water remains visi-		kit is available as a special ac-
	is exceeded.
ble in the drum.		cessory.
The END light		Switch off the machine and
flashes twice an
acoustic signal is	The drain pump is blocked.	disconnect the mains plug.
emitted twice.		Clean the drain pump.
	For siphon attachments:	Clean the siphon.
	the siphon is blocked.
		Wait until the programme has
		ended, the DOOR light goes off
The door cannot be		and the END light is lit.
		If it is necessary to open the
opened when the
washing machine	Door is locked due to high	door immediately,
is on.	water level, or high tempera-	Turn the programme selector
START/PAUSE	ture.	to OFF; then turn it to DRAIN.
and DOOR lights		Press the START/PAUSE but-
come on.		ton.
		When the water has been
		pumped out, the door can be
		opened.
		The programme continues
		when power is restored.
	The failure may be caused by	If washing has to be taken out
Power failure dur-	a blown house fuse or by a
		during a power cut:
ing a wash pro-	mains supply fault into the
		Turn the control knob to OFF.
gramme (all	house.
		Carry out emergency emptying
indicator lights	(For safety reasons, the door
		(see Section "Carry out emer-
are off).	remains locked for around
		gency emptying“).
	2 minutes.)
		After about 2 minutes,
		the door can be opened by
		pulling on the handle.

30