Electrolux 50620 manual Malfunction Possible Cause Remedy Threaded fitting on

		Operating Instructions
Malfunction	Possible Cause	Remedy
	Threaded fitting on the	Tighten the inlet hose con-
	water inlet hose is leaking.	nections.
	The inlet hose has a leak.	Check the inlet hose and if
Water runs out from		necessary replace it.
under the washing
	The drain pump cover is not	Tighten cover by turning
machine.
	tight.	clockwise.
	Washing is caught in the	Abort the program, remove
		the washing caught in the
	door.
		door, start a new program.
Fabric softener is not	Suction cap in the fabric	Clean detergent dispenser
added, compartment
	softener compartment is not	drawer, place suction cap
À for fabric softener
	correctly fitted or is blocked.	firmly in position.
is filled with water.
Appliance does not	RINSE HOLD selected.	Deselect RINSE HOLD.
spin, water in the
	SOAKING program is finished	Release SOAKING button
drum.
		(the main wash starts).
	Drain hose is kinked.	Remove kink.
	Drain hose to high.	Check installation
		instructions.
Washing is not spun
		Switch off the machine and
properly, water is still
	Drain pump is blocked.	pull the plug out of the
visible in the drum.
		socket, clean the drain pump.
	The water drainage system is	Clean the blockage.
	blocked.
It is not possible to	The door is locked for safety	Wait 1-2 minutes after the
open the door.	reasons.	end of the program.
	Water tap is not fully open.	Open water tap fully.
Remnants of detergent	The inlet hose filter in the
	coupling of the inlet hose at	Clean filter.
are building up in the
	the tap is blocked.
detergent dispenser
drawer.	The inlet valve filter in the
	coupling of the inlet hose at	Clean filter.
	the appliance is blocked..

This is probably due to using

Rinse water is cloudy. a detergent with a high silicate content.

No negative impact on the rinsing results, try using liquid detergent.

29