
WRINKLE PREVENT” Feature
(on some models)
When you are unable to remove a load from I the dryer as soon as it
stops, wrinkles can form. The WRINKLE PREVENT feature tumbles the load without heat every few minutes up to 45 minutes after the cycle ends. This tumbling rearranges and fluffs the load to avoid wrinkles.
You do not have to set the Cycle Control Knob for the WRINKLE PREVENT feature. If you do not open the dryer door within a few minutes after the cycle stops, the WRINKLE PREVENT feature takes over to protect the load.
A signal sounds every few minutes when WRINKLE PREVENT is running. The signal and cycle stop when you open the dryer door.
End of cycle signal
(on some models)
The dryer sounds a signal to let you know when the cycle is finished. The signal is helpful when you are drying permanent press, synthetics, and other items that should be removed from the dryer as soon as it stops. The End of Cycle On/Off Selec- tor is part of the Start Button, as shown.
NOTE: Unless you turn the Selector to Off, the end of cycle signal sounds at the end of the drying cycle.