Electrical Requirements

WARNING: This appliance must be earthed!

Supply

REFER TO THE RATING PLATE FOR VOLTAGE AND CURRENT

REQUIREMENTS. (see diagram for location.)

The flexible mains lead is supplied fitted with a BS1363 plug and

with a 13 amp BS1362 fuse.

The plug should be connected to the mains supply via a suitable

switched socket which is accessible after installing your dryer.

Changing

If it is necessary to fit a replacement fuse, it must be a 13 amp

the fuse

ASTA approved to BS1362 type.

Moulded plug

WARNING: The plug must not be used without a fuse cover.

If a replacement fuse holder/cover is required, it must be of the

same colour coding or wording as shown on the base of the plug.

Replacements are available from your Spares stockist.

Changing

The wires in the mains lead are coloured in accordance with the

the plug

following:

GREEN/YELLOW - EARTH

BLUE

- NEUTRAL

BROWN

- LIVE

Rewirable plug

If a replacement plug is to be fitted, the appropriate wire must be

connected to the correct terminal,as follows:

GREEN &

YELLOW TO

EARTH

Connect:

Green/Yellow to terminal marked Earth or Green or

Blue to terminal marked Neutral or N or Black

Brown to terminal marked Live or L or Red.

13 AMP

If the plug being replaced is a non-rewirable type then the cut-off

FUSE

plug must be disposed of safely. DO NOT leave where it can be

BROWN

BLUE TO

TO LIVE

inserted into a socket and create a shock hazard.

CORD

NEUTRAL

CLAMP

Changing the

Should the mains lead ever require replacing at any time please

mains cable

contact your nearest Service Centre. A charge will be made for the

replacement of the mains lead or if you require a longer lead.

The mains lead must only be replaced by a specially prepared

cable obtainable from your Spares Stockist and fitted by a

qualified electrician.

NOTE: IF IN DOUBT ABOUT ANY OF THE ABOVE CONSULT A

QUALIFIED ELECTRICIAN.