JVC CA-HXZ9 manual Connecting Speakers, To connect an outdoor AM antenna

English

AM antenna Connecting Speakers

1

2

Vinyl-covered wire

(not supplied)

3

AM loop antenna

(supplied)

1If cords are covered with insulation, twist the core of the cord at the end of each cord, then remove the insulation.

2Connect the AM loop antenna to the AM LOOP terminals as illustrated.

3Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. The AM loop antenna must remain connected.

To connect front speakers and subwoofer

1
2			3
Speaker cords			Speaker cords
Black	Blue	Black	Blue	Black
	Red		Red
	Speaker		Speaker
	cords		cords
	from right		from left
	subwoofer		subwoofer
	terminal		terminal
Right		Subwoofer		Left
main speaker			main speaker

1If cords are covered with insulation, twist the core of the cord at the end of each cord, then remove the insulation.

2Insert the end of the speaker cord into the

terminal as illustrated.

Match the same polarity: (+) to (+) and (–) to (–).

3Close the speaker terminals.

For better reception of both FM and AM

•Make sure the antenna conductors do not touch any other terminals and connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

• DO NOT connect more than one speaker to each speaker terminal.

•DO NOT push or pull the speakers as this will damage the foot spacers at the bottom of the speakers.

7