Indesit IWD 7145 K manual Installation, Unpacking and levelling, Electric and water connections

Page 2

Installation

 

! Keep this instruction manual in a safe place for

GB

future reference. Should the appliance be sold, tran-

 

 

sferred or moved, make sure the instruction manual

 

 

accompanies the washing machine to inform the

 

new owner as to its operation and features.

 

! Read these instructions carefully: they contain

 

vital information on installation, use and safety.

Unpacking and levelling

Unpacking

1. Unpack the washing machine.

2. Check whether the washing machine has been damaged during transport. If this is the case, do not install it and contact your retailer.

3. Remove the 4 pro- tective screws and the rubber bush with the respective spacer, si- tuated on the rear of the appliance (see also the

installation leaflet).

4.Seal the gaps using the plastic plugs provided.

5.Keep all the parts: you will need them again if the washing machine needs to be moved to another location.

! Packaging materials are not children’s toys.

Levelling

Your machine may make a considerable amount of noise if the two front feet have not been adju- sted correctly.

1.Install the washing machine on a flat sturdy floor, without resting it up against walls, furniture cabinets or other.

2.If the floor is not per-

fectly level, compensate for any unevenness by tightening or loosening the adjustable front feet (see figure); the angle of inclination, measu- red according to the worktop, must not ex-

ceed 2°.

Levelling your appliance correctly will provide it with stability and avoid any

vibrations, noise and shifting during operation. If it is placed on a fitted or loose carpet, adjust the feet in such a way as to allow enough room for ventilation beneath the washing machine.

Electric and water connections

Connecting the water inlet hose

1. Connect the supply pipe by screwing it to a cold water tap using a 3/4 gas threaded connection (see figure). Before performing the connection, allow the water to run freely until it is perfectly clear.

2. Connect the other end of the water inlet hose to the washing machine, screwing it onto the appliance’s cold water inlet, situated on the top right-hand side on the rear of the appliance (see figure).

3.Make sure there are no kinks or bends in the hose.

!The water pressure at the tap must be within the values indicated in the Technical details table (on the page 5).

!If the water inlet hose is not long enough, contact a specialist store or an authorised serviceman.

!Ensure that the supply taps are allowing wa- ter through. Old taps may seize in the closed position and thus prevent water reaching the machine.

2

Image 2
Contents Instructions for use Washing MachineUnpacking and levelling InstallationInstallation leaflet Electric and water connectionsDisposing of the plug Replacing the fuseRemoving the plug First wash cycle Disposing of the applianceTechnical data Maximum pressureCare and maintenance This appliance can be used by children aged Precautions and tipsGeneral safety DisposalDescription of the washing machine and starting a wash cycle Indicator lights Starting a wash cycleWash cycles Table of wash cyclesPersonalisation Setting the temperatureSetting the spin speed FunctionsLoad balancing system Detergents and laundryDetergent dispenser drawer Preparing the laundryPossible causes / Solutions TroubleshootingProblem Etc. Try the programme again using a different load Assistance Essential Contact Information After Sales Service195102171.00 Recycling & Disposal Information