Indesit G75C manual Controls, Never Wind the Timer Control ANTI-CLOCKWISE

The Controls

Start switch Empty water light

Heat Selection Switch	Timer
	Control

Setting the timer The drying time for both heat settings is controlled by the timer. All you have to do is turn the Timer Control clockwise until the required time appears in line with the indicator.

NEVER WIND THE TIMER CONTROL ANTI-CLOCKWISE.

The “Guide to Drying Times” section will tell you how much time you’ll need for various loads.

Selecting the	To select high heat (Cottons), the Heat Selection switch must be IN.
required Heat	To select Low heat (Acrylics and Synthetics) the Heat Selection switch
Setting	must be OUT.
	See section “Guide to Drying Times”.
Starting the Dryer	Press and release the START button to commence a drying program
	(The drying time must have been selected first).
	NOTE: If the door is opened during a programme the
	Dryer will automatically stop.
	To continue the programme after closing the door, the
	START button must be pressed.
Empty Water	This light will glow when the water container is full.
Light	You should not wait for this light to glow before emptying the water
	container, but empty it after each load (see section “Emptying the
	Water Container”).
	NOTE: When the light glows you must stop the dryer and empty the
	water container.
	If the water light glows during a drying cycle the timer will advance to
	the Cool Tumble Phase without drying the load.
	The light will take approximately 10 seconds to go out after replacing
	the empty container.

9