Indesit IWE81281K manual Installation, Unpacking and levelling

Installation

GB	! This instruction manual should be kept in a safe place for
	future reference. If the washing machine is sold, transferred
	or moved, make sure that the instruction manual remains
	with the machine so that the new owner is able to familiari-
	se himself/herself with its operation and features.
	! Read these instructions carefully: they contain vital infor-
	mation relating to the safe installation and operation of the
	appliance.
	Unpacking and levelling
	Unpacking
	1. Remove the washing machine from its packaging.
	2. Make sure that the washing machine has not been
	damaged during the transportation process. If it has been
	damaged, contact the retailer and do not proceed any
	further with the installation process.
	3. Remove the 4 protective
	screws (used during tran-
	sportation) and the rubber
	washer with the correspon-
	ding spacer, located on the
	rear part of the appliance
	(see figure).

4.Close off the holes using the plastic plugs provided.

5.Keep all the parts in a safe place: you will need them again if the washing machine needs to be moved to ano- ther location.

!Packaging materials should not be used as toys for children.

Levelling

1.Install the washing machine on a flat sturdy floor, without resting it up against walls, furniture cabinets or anything else.

2.If the floor is not perfectly level, compensate for any

unevenness by tightening or loosening the adjusta- ble front feet (see figure); the angle of inclination, measured in relation to the worktop, must not exceed 2°.

Levelling the machine correctly will provide it with stability, help to avoid vibrations and excessive noise and prevent it from shifting while it is operating. If it is placed on carpet or a rug, adjust the feet in such a way as to allow a sufficient ventilation space underneath the washing machine.

Connecting the electricity and water supplies

Connecting the water inlet hose

1. Connect the supply pipe by screwing it to a cold water tap using a ¾ gas threaded connection (see figure).

Before performing the con- nection, allow the water to run freely until it is perfectly clear.

2. Connect the inlet hose to the washing machine by screwing it onto the corre- sponding water inlet of the appliance, which is situa- ted on the top right-hand side of the rear part of the appliance (see figure).

3. Make sure that the hose is not folded over or bent.

!The water pressure at the tap must fall within the values indicated in the Technical details table (see page 5).

!If the inlet hose is not long enough, contact a specialised shop or an authorised technician.

!Never use second-hand hoses.

!Use the ones supplied with the machine.

2