Installation
Keep this instruction manual in a safe place for
GB | future reference. Should the appliance be sold, |
| |
| transferred or moved, make sure the instruction |
| manual accompanies the washing machine to inform |
| the new owner as to its operation and features. |
| Read these instructions carefully: they contain |
| vital information on installation, use and safety. |
| Unpacking and levelling |
| Unpacking |
| 1. Unpack the washing machine. |
| 2. Check whether the washing machine has been |
| damaged during transport. If this is the case, do |
| not install it and contact your retailer. |
| 3. Remove the four |
| protective screws and |
| the rubber washer with |
| the respective spacer, |
| situated on the rear of |
| the appliance (see |
| figure). |
4.Seal the gaps using the plastic plugs provided.
5.Keep all the parts: you will need them again if the washing machine needs to be moved to another location.
Packaging materials are not children's toys.
Levelling
Your machine may make a considerable amount of noise if the two front feet have not been adjusted correctly.
1.Install the washing machine on a flat sturdy floor, without resting it up against walls, furniture cabinets or other.
2. If the floor is not perfectly level, compen- sate for any unevenness by tightening or loosening the adjustable front feet (see figure); the angle of inclination, measured according to the worktop, must not exceed 2°.
Levelling your appliance correctly will provide it with stability and avoid any vibrations, noise and shifting during operation. If it is placed on a fitted or loose carpet, adjust the feet in such a way as to allow enough room for ventilation beneath the washing machine.
Electric and water connections
Connecting the water inlet hose
1. Connect the supply
pipe to the water mains using a gas 3/4
attachment, fitting
the rubber gasket and the filter supplied with
the appliance and
ensuring that they are
fimly tightened to the
taps.
The water supply marked C must be connected to the cold water tap; the pipe marked H must be connected to the hot water tap. Both pipes may be connected to the cold water tap using the special Y connection with multiple attachments, supplied with the appliance (see figure).
Before making the connection, allow the water to run freely until it is perfectly clear.
2. Connect the other end of the water inlet hose to the washing machine,
screwing it onto the appliance's cold water inlet, situated on the top
3. Make sure there are no kinks or bends in the hose.
The water pressure at the tap must be within the values indicated in the Technical details table (on the next page).
If the water inlet hose is not long enough, contact a specialist store or an authorised serviceman.