Care and maintenance
Cutting off the water and electricity GB supplies
•Turn off the water tap after every wash cycle. This will limit wear on the hydraulic system inside the washing machine and help to prevent leaks.
•Unplug the washing machine when cleaning it and during all maintenance work.
Cleaning the washing machine
The outer parts and rubber components of the appliance can be cleaned using a soft cloth soaked in lukewarm soapy water. Do not use solvents or abrasives.
2. Unscrew the lid by rotating it
3.Clean the inside thoroughly.
4.Screw the lid back on.
5.Reposition the panel, making sure the hooks are securely in place before you push it onto the appliance.
Cleaning the detergent dispenser drawer
Checking the water inlet hose
1 |
2 |
To remove the drawer, press lever (1) and pull the drawer outwards (2) (see figure).
Wash it under running water; this procedure should be repeated frequently.
Check the inlet hose at least once a year. If there are any cracks, it should be replaced immediately: during the wash cycles, water pressure is very strong and a cracked hose could easily split open.
!Never use
Cleaning the pump
The washing machine is fitted with a
!Make sure the wash cycle has finished and unplug the appliance.
To access the
1 |
|
2 | 3 |
|
1.Take off the cover panel on the front of the machine by first pressing it in the centre and then pushing downwards on both sides until you can remove it (see figures).
12