Indesit WME 126 manual Instructions for the fitter, See figures below

	Instructions for the fitter
GB
	Mounting the wooden panel onto the door
	and inserting the machine into cabinets:
	In the case where the machine must be shipped
	for final installation after the wooden panel has
	been mounted, we suggest leaving it in its ori-
	ginal packaging. The packaging was designed
	to make it possible to mount the wooden panel
	onto the machine without removing it completely
	(see figures below).
	The wooden panel that covers the face of
	the machine must not be less than 18 mm in
	thickness and can be hinged on either the right
	or left. For the sake of practicality when using
	the machine, we recommend that the panel be
	hinged on the same side as the door for the
	machine itself - the left.

Door Mounting Accessories (Fig. 1-2-3-4-5).

	N° 2 Hinge Supports
			N° 2 Hinges
Fig. 1		Fig. 2

N° 1 Magnet	N° 1 Magnet plate
Fig. 3	Fig. 4

AB

CD

E

	N° 1 Rubber plug		N° 4 Spacers
Fig. 5		Fig. 4/B

-No. 6 type A self-threading screws, l =13 mm.

-No. 2 type B metric, countersunk screws, l =25; for fastening the magnet plate to the cabinet.

-No. 4 type C metric screws, l =15 mm; for mounting the hinge supports to the cabinet.

-No. 4 type D metric screws, l =7 mm; for mounting the hinges on the supports.

Mounting the Parts onto the Face of the Machine.

-Fit the hinge supports to the appliance front panel, positioning the hole marked with an arrow in fig. 1 so that it is on the inner side of the front panel. Fit a spacer (fig. 4/B) between the surfa- ces using type C screws.

-Fit the magnet plate at the top of the opposite side, using type B screws to fix two spacers (fig. 4/B) between the plate and the surface.

6