Indesit Washing Machine Settings and Dimensions Guide for IWME126

Personalisations

Setting the temperature

Turn the TEMPERATURE knob to set the wash temperature (see Programme table on page 10).	GB
The temperature can be lowered, or even set to a cold wash ( ).

Setting the spin speed

Turn the SPIN SPEED knob to set the spin speed for the programme selected.

The maximum spin speeds for each programme are as follows:

Programmes	Maximum spin speed
Cottone	1200 rpm
Synthetics	800 rpm
Wool	600 rpm
Silk	no

The spin speed can be lowered, or the spin cycle can be excluded altogether by selecting symbol . The washing machine will automatically prevent you from selecting a spin speed higher than the maximum speed for each programme.

Note: to avoid excessive vibrations, before every spin cycle the machine distributes the load in a uniform manner by continuously rotating the drum at a speed which is slightly faster than the normal washing speed.

When, despite repeated attempts, the load is still not evenly distributed, the machine spins at a lower speed than the set frequency.

If the load is excessively unbalanced, the machine attempts to distribute it instead of spinning.

The balancing attempts may extend the total duration of the cycle, up to a maximum of 10 minutes.

Functions

To enable a function:

1.press the button corresponding to the desired function, according to the table below;

2.the function is enabled when the corresponding button is illuminated.

Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the programme set.

Function	Effect	Comments		Enabled with
				programmes:
	Delays the start	Press the button repeatedly until the LED corresponding to the
		desired delay is turned on.		All
	of the wash by	The fifth time the button is pressed, the function will be disabled.
Delay Timer	up to 9 hours.	N.B.: Once you have pressed the Start/Reset button, the delay
		can only be decreased if you wish to modify it.
	Bleaching cycle	Please remember to pour the bleach into extra compartment 4		2, 3, 4, 5,
	designed to
		(see page 12).
Stain	remove the			Rinse cycle.
		This function is incompatible with the EASY IRON function.
removal	toughest stains.
	This option	When this function is set, programmes 4, 5, 7 will end with the
	reduces the	laundry left to soak (Anti-crease) and the Rinse cycle phase		3, 4, 5, 7, 8,
	amount of	LED	will flash.
	creasing on	- to conclude the cycle, press the START/RESET button;		9, 10, Rinse
	fabrics, making	- to run the draining cycle alone, set the knob to the relative		cycle.
Easy iron	them easier to	symbol	and press the START/RESET button.
	iron.	This function is incompatible with the STAIN REMOVAL function.
	Increases the			1, 2, 3, 4, 5,
		Recommended when the appliance has a full load or with large		8, 9, 10, 12,
	efficiency of the
		quantities of detergent.		13, Rinse
	rinse.
Extra Rinse				cycle.

11