Personalisations
Setting the temperature
Turn the VARIABLE TEMPERATURE knob to set the wash temperature (see Programme table on page 8). | G B |
| |
The temperature can be lowered, or even set to a cold wash (Cold). |
|
Functions
To enable a function:
1.press the button corresponding to the desired function, according to the table below;
2.the function is enabled when the corresponding button is illuminated.
Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the programme set.
Function | Effect | Comments | Enabled with | |
programmes: | ||||
|
|
| ||
|
|
|
| |
| Allows for an |
|
| |
| impeccable wash, |
| A, B, C, D, | |
| visibly whiter | This function is incompatible with the QUICK WASH function. | ||
| E, F, G, H | |||
Super | than a standard |
| ||
|
| |||
Wash | Class A wash. |
|
| |
|
|
|
| |
| This option | When this function is set, programmes F, G, H ,K, L, N will end |
| |
| reduces the |
| ||
| with the laundry left to soak | All | ||
| amount of | |||
| phase LED will flash. | programmes | ||
| creasing on | |||
| - to conclude the cycle, press the START button; | except for | ||
| fabrics, making | |||
| - to run the draining cycle alone, set the knob to the relative | A, B, J, R | ||
| them easier to | |||
| programme (R) and press the START button. |
| ||
Easy Iron | iron. |
| ||
|
| |||
|
|
|
| |
| Cuts the |
|
| |
Quick | duration of the | This function is incompatible with the SUPER WASH function. | A, B, C, D, | |
wash cycle by | E, F, G, H | |||
| ||||
Wash | 30%. |
|
| |
|
|
|
| |
Extra | Increases the | Recommended when the appliance has a full load or with large | A, B, C, D, E, | |
efficiency of | ||||
quantities of detergent. | F, G, H, M, N | |||
Rinse | the rinse. | |||
|
| |||
|
|
|
|
Note: to avoid excessive vibrations, before every spin cycle the machine distributes the load in a uniform manner by continuously rotating the drum at a speed which is slightly faster than the normal washing speed.
When, despite repeated attempts, the load is still not evenly distributed, the machine spins at a lower speed than the set frequency.
If the load is excessively unbalanced, the machine attempts to distribute it instead of spinning. The balancing attempts may extend the total duration of the cycle, up to a maximum of 10 minutes.
9