First wash cycle, Technical data | Hotpoint SWMD 10637 guide

As the colours of the wires in the lead may not GB correspond with the coloured markings iden-

tifying the terminals in your plug, proceed as follows:

Connect Green & Yellow wire to terminal marked E or or coloured Green or Green & Yellow.

Connect Brown wire to terminal marked L or coloured Red.

Connect Blue wire to terminal marked N or coloured Black.

If a 13 amp plug (BS 1363) is used it must be fitted with a

13 amp fuse, either in the plug or adaptor or at the distribution board.

If you are in any doubt regarding the electrical supply to your machine, consult a qualified electrician before use.

How to connect an alternative plug:

The wires in this mains lead are coloured in accordance with the following code:

BLUE		NEUTRAL (N)
BROWN		LIVE (L)
GREEN & YELLOW		EARTH (E)

GREEN &
YELLOW
BROWN	13 ampere fuse
BROWN
BLUE	CROSS-BAR
	CORD GRIP

Disposing of the appliance:

When disposing of the appliance please re- move the plug by cutting the mains cable as close as possible to the plug body and dispo- se of it as described on the previous page.

!The washing machine should not be installed in an outdoor environment, not even where the area is sheltered, because it may be very dangerous to leave it exposed to damp, rain and thunderstorms.

!When the washing machine is installed, the mains socket must be within easy reach.

!Do not use extensions or multiple sockets.

!The power supply cable must never be bent or dangerously compressed.

!The power supply cable must only be repla- ced by an authorised serviceman.

Warning! The company denies all liability if and when these norms are not respected.

The first wash cycle

Once the appliance has been installed, and before you use it for the first time, run a wash cycle with detergent and no laundry, using the programme “Auto Clean” (see “Cleaning the washing machine”).

Technical data

	Model			SWMD 10637

				width 59.5 cm
	Dimensions			height 85 cm
				depth 60.5 cm
	Capacity			from 1 to 10 kg

	Electrical			please refer to the technical
	Electrical			data plate fixed to the ma-
	connections			data plate fixed to the ma-
	connections			chine
				maximum pressure
	Water con-			1 MPa (10 bar)
	Water con-			minimum pressure
	nections			minimum pressure
	nections			0.05 MPa (0.5 bar)
				0.05 MPa (0.5 bar)
				drum capacity 71 litres
	SPIN			up to 1600 rotations per
	SPIN			minute
				minute
	Test wash			programme 2 (60°)
	cycles in			programme 2 (60°)
	accordan-			(1st press of the button);
	ce with			Cotton Standard 60°C.
	directives			programme 2 (40°)
	1061/2010			(2nd press of the button);
	and			Cotton Standard 40°C.
	1015/2010
				This appliance conforms to
				the following EC Directives:
				- 2004/108/EC (Electroma-
				gnetic Compatibility)
				- 2006/95/EC (Low Voltage)
				- 2012/19/EU

Disposing of the appliance:

The first wash cycle

Technical data

(2nd press of the button);