Hotpoint HSTB 621 manual Indicator lights, Starting a wash cycle

Page 9

Indicator lights

The indicator lights provide important information. This is what they can tell you:

Wash cycle phase indicator lights

Once the desired wash cycle has been selected and has begun, the indicator lights switch on one by one to indicate which phase of the cycle is currently in progress.

Wash

Rinse

Spin

Pump out

End of wash cycle

Function buttons and corresponding indicator lights When a function is selected, the corresponding indicator light will illuminate.

If the selected function is not compatible with the program- med wash cycle, the corresponding indicator light will flash and the function will not be activated.

If a function which is incompatible with another function selected previously, only the most recent selection will remain active.

Door locked indicator light

If this indicator light is on, the appliance door is locked to GB prevent it from being opened accidentally; to avoid any

damage, wait for the indicator light to switch off before you open the appliance door (wait approximately 3 minutes).

!If the START/PAUSE indicator light (orange) flashes rapidly at the same time as the function indicator light, this indicates a problem has occurred (see “Troubleshooting”).

Starting a wash cycle

1.Switch the washing machine on by pressing the ON/OFF button. All the indicator lights will turn on for a few seconds, then only the indicator lights relative to the selected programme settings will remain lit and the START/PAUSE indicator light will flash.

2.Load the laundry and close the door.

3.Set the WASH CYCLE knob to the desired programme.

4.Set the washing temperature (see “Personalisation”).

5.Measure out the detergent and washing additives (see “Detergents and laundry”).

6.Select the desired functions.

7.Start the wash cycle by pressing the START/PAUSE button and the corresponding indicator light will remain lit in a fixed manner, in green.

To cancel the set wash cycle, pause the machine by pressing the START/PAUSE button and select a new cycle.

8.At the end of the wash cycle the indicator light will switch on. The DOOR LOCKED indicator light will switch off, indi- cating that the door may be opened (wait approximately 3 minutes). Take out your laundry and leave the appliance door ajar to make sure the drum dries completely. Switch the washing machine off by pressing the ON/OFF button.

9

Image 9
Contents Washing Machine Instructions for useInstallation Unpacking and levellingElectric and water connections Replacing the fuse First wash cycle Technical dataPage Care and maintenance General safety Precautions and tipsThis appliance can be used by children aged DisposalDescription of the washing machine and starting a wash cycle Starting a wash cycle Indicator lightsTable of wash cycles Wash cyclesSetting the temperature PersonalisationFunctions Detergent dispenser drawer Detergents and laundryPreparing the laundry Garments requiring special careTroubleshooting ProblemPossible causes/Solution Page Assistance GuaranteeGBIndesit Company 195122393.00Viale Aristide Merloni Fabriano AN