Hotpoint ULTIMA guide

The machine is noisy.

The machine wont spin properly.

The machine leaks from the di- spenser.

The machine leaks (other than dispenser).

•There will always be some motor, pump and drum noise during spin.

•Out of Balance detected when attempting to go into a spin cycle - If this happens the machine will continue to try to repeat the distribution of the load required before the machine will go into higher SPIN s - This will increase the programme time accordingly. This is a safety feature to prevent damage. Out of Balance can be caused by washing a single heavy item (eg duvet, quilt, etc). - Try the programme again using a different load.

•The dispenser drawer is blocked with detergent and requires cleaning.

•The water pressure is too high and requires turning down - turn down the tap on the water supply pipe slightly and try again.

•The machine is tilting forwards - It must be level when in its final position.

•The fill hose is loose, check both the cabinet and tap ends.

•The fill hose is tight but still leaks, if so replace the rubber washers, or the fill hose is missing the rubber washer.

•The drain hose is not fixed in properly.

The indicator lights on the console are flashing rapidly.

The machine smells.

The machine door cannot be opened.

Door Seal damaged at the bottom.

The water level is too low when the machine is washing.

There is too much foam.

•Switch off the machine and unplug it, wait for approximately 1 minute and then switch it back on again If the problem persists contact the Technical Assistance Service.

•The machine requires a service wash. Run a “Auto Clean” wash cycle with detergent and no laundry

•The door will not open until the door lock indicator light goes out shortly after the program has finished.

•The door seal has drainage holes at the bottom - This is normal.

•The water level is correct if it can be seen at the bottom of the door.

•The detergent is not suitable for machine washing (it should display the text ‘for washing machines’ or ‘hand and machine wash’ or the like).

•Too much detergent was used - less detergent is required in soft water.

After completing the programme, or before starting a programme, the machine has turned itself off (no lights).

General.

•To comply with new energy saving regulations the machine is fitted with an automatic standby system. Press ‘ON/OFF’ button for 3 seconds to activate the machine, it can then either be switched off or a new programme selected.

•Your washing machine contains sensors that monitor progress during the wash cycle (eg: Water Levels, Temperatures, Out of Balance loads, Wash time/pro- gress).

Normally, if your machine successfully completes the cycle, there is unlikely to be anything wrong!

Remember, you will be charged for a service call for problems caused by incorrect installation, as indica- ted on pages 2 to 4.

Not emptying contents from pockets may cause pump or drain blockages, or may damage the machine.

Do not wash items which do not have a wash label, or wash items that are not intended as machine washable.

ULTIMA specifications

The Hotpoint ULTIMA series is a line of innovative home appliances designed to enhance your kitchen experience with their advanced features and sleek design. Renowned for their reliability and performance, these appliances cater to a variety of cooking and food preservation needs, making them a popular choice for households looking for efficiency and convenience.

One of the standout features of the Hotpoint ULTIMA range is its unique Smart Technology. This includes sensors that monitor cooking parameters, adjusting heat and time automatically to ensure perfectly cooked meals every time. Whether you're baking, roasting, or grilling, the ULTIMA appliances offer precise control that saves you time and energy.

The ULTIMA line also boasts an impressive energy efficiency rating. With advancements in technology, these appliances consume less energy while delivering exceptional performance. This not only helps reduce your carbon footprint but also decreases your utility bills, making it an environmentally friendly choice for modern kitchens.

Another notable characteristic is the spacious interior designs that the ULTIMA ovens offer. With varying capacities, users can select models that best suit their household size. The roomy interiors allow for the cooking of large meals, making it perfect for families or those who love to host gatherings.

Moreover, the ULTIMA series features an easy-to-clean design. The interiors are often coated with self-cleaning enamel, which helps reduce food residue and grime buildup. Additionally, the removable components make it simple to maintain the appliance, ensuring it remains in optimal condition for years to come.

Hotpoint's commitment to user safety is evident in the ULTIMA appliances as well. Many models come equipped with safety features such as cool touch doors, child lock options, and automatic shut-off functions to prevent accidents during cooking.

Incorporating stylish aesthetics, the ULTIMA series is designed to complement any kitchen decor. With a variety of finishes available, including stainless steel and sleek black, these appliances not only perform well but also add a modern touch to your culinary space.

In summary, the Hotpoint ULTIMA series combines cutting-edge technology, energy efficiency, spacious designs, ease of cleaning, safety features, and appealing aesthetics, making it an ideal choice for those who cherish quality and performance in their kitchen appliances.