Whirlpool W10150610A, W10150611A Dryer Care, CleaningtheDryer Location, CleaningtheLintScreen

Page 5

Style 2: Your drying rack does not have front legs. Do not remove the lint screen. Slide drying rack over the bottom of the dryer door opening. Push down to secure rack on frame.

2.Put wet items on top of rack, leaving space between items. Do not allow items to hang over the edge of the rack. Close the door.

3.Select a timed drying cycle and temperature, or an air cycle. Items containing foam, rubber, or plastic must be dried on a clothesline or by using an air cycle. Refer to the following table.

4.Start the dryer. Reset cycle to complete drying, if needed.

Rack Dry

Cycle

Temp

Time

 

 

 

 

Washable wool items (block

Timed

Low

60 min.

to shape, lay flat on rack)

Drying

 

 

 

 

 

 

Stuffed toys/pillows (cotton

Timed

Low

60 min.

or polyester filled)

Drying

 

 

 

 

 

 

Stuffed toys/pillows

Air

N/A

90 min.

Foam rubber filled

(no heat)

 

 

DRYER CARE

CleaningtheDryer Location

Keep dryer area clear and free from items that would obstruct the flow of combustion and ventilation air.

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from dryer.

Place dryer at least 18 inches (46 cm) above the floor for a garage installation.

Failure to do so can result in death, explosion, or fire.

CleaningtheLintScreen

Clean lint screen before each load. A screen blocked by lint can increase drying time.

IMPORTANT:

Do not run the dryer with the lint screen loose, damaged, blocked or missing. Doing so can cause overheating and damage to both the dryer and fabrics.

If lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint.

Every Load Cleaning

Style 1:

1.The lint screen is located on top of the dryer. Pull the lint screen toward you. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove.

2.Push the lint screen firmly back into place.

Style 2:

1.The lint screen is located in the door of the dryer. Pull the lint screen straight up. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove.

2.Push the lint screen firmly back into place.

As Needed Cleaning

1.Roll lint off the screen with your fingers.

2.Wet both sides of lint screen with hot water.

3.Wet a nylon brush with hot water and liquid detergent. Scrub lint screen with the brush to remove residue buildup.

4.Rinse screen with hot water.

5.Thoroughly dry lint screen with a clean towel. Replace screen in dryer.

CleaningtheDryerInterior

1.Apply a liquid, nonflammable household cleaner to the stained area of the drum and rub with a soft cloth until stain is removed.

2.Wipe drum thoroughly with a damp cloth.

3.Tumble a load of clean cloths or towels to dry the drum.

NOTE: Garments that contain unstable dyes, such as denim blue jeans or brightly colored cotton items, may discolor the dryer interior. These stains are not harmful to your dryer and will not stain future loads of clothes. Dry unstable dye items inside out to avoid transfer of dye.

RemovingAccumulatedLint

From Inside the Dryer Cabinet

Lint should be removed every 2 years, or more often, depending on dryer usage. Cleaning should be done by a qualified person.

From Inside the Exhaust Vent

Lint should be removed every 2 years, or more often, depending on dryer usage.

5

Image 5 Contents
Accessories AssistanceorServiceYour safety and the safety of others are very important Dryer SafetyWhat to do if YOU Smell GAS CheckingYourVentDryingRackOption Dryer USEStartingYourDryer CleaningtheLintScreen CleaningtheDryer LocationCleaningtheDryerInterior Dryer CareVacationandMovingCare TroubleshootingChangingtheDrumLight DryerOperationDryerResults To locate FSP replacement parts in your area Replacement partsIs the electric dryer being used for the first time? Call
Related manuals
Manual 8 pages 34.39 Kb