Whirlpool CEDC392JQ0 manual Install Vent System, Connect Vent, Install casters

Page 9

4.Insert cord brackets into slotted holes in rear panel and secure with screws provided.

NOTE: Power supply cord may be wrapped around the brackets for storage convenience when dryer is not in use.

Install casters

1.Lay the dryer on its side.

2.Use the carton to prevent damage to the dryer.

3.Screw casters into dryer base at four corners and tighten securely.

4.Set the dryer upright. In doing so, be careful that the dryer does not roll away from you.

■As stated in “Location Requirements”, it is important that the dryer be located on a level surface.

■Leveling feet (Part No. 51594200) for use in permanent installations may be purchased. See “Assistance or Service.”

Install Vent System

1.(Optional) Put on safety glasses and gloves.

2.Before installing the vent system, be sure to remove the wire exhaust guard that is located at the exhaust outlet.

3.Install exhaust hood. Use caulking compound to seal exterior wall opening around exhaust hood.

4.Connect vent to exhaust hood. Vent must fit inside exhaust hood. Secure vent to exhaust hood with 4 in. (10.2 cm) clamp.

5.Run vent to dryer location. Use the straightest path possible. See “Determine Vent Length”. Avoid 90º turns. Use duct tape to seal all joints.

Connect Vent

1.Using a 4 in. (10.2 cm) clamp, connect vent to exhaust outlet in dryer. If connecting to existing vent, make sure the vent is clean. The dryer vent must fit over the dryer exhaust outlet and inside the exhaust hood. Make sure the vent is secured to exhaust hood with a 4 in. (10.2 cm) clamp.

2.Move dryer into final position. Do not crush or kink vent. Make sure dryer is level.

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Use&CareGuide Electric DryerTable of Contents Your safety and the safety of others are very important Dryer SafetyParts and Features Installation Instructions Tools and PartsLocation Requirements Minimum installation spacing Recessed Area and Closet InstallationRecommended/Minimum Clearances Mobile Home-Additional Location RequirementsVenting Requirements Electrical RequirementsVent Length Chart Determine Vent LengthSpecial Venting Information for Mobile Homes Install Vent System Install castersConnect Vent Dryer USE Complete InstallationStarting Your Dryer Then check the followingDrying, Cycle, and Temperature Tips Stopping and RestartingLoading Clothes Permanent Press Cycle End of Cycle SignalTimed Dry Cycle Air CycleCleaning the Dryer Interior Cleaning the Lint ScreenDryer Care Removing Accumulated Lint from Inside the Dryer CabinetTroubleshooting If you need replacement parts Assistance or ServiceFor assistance or service For further assistanceCrosley Dryer Warranty Whirlpool Corporation will not pay for8521904

CEDC392JQ0 specifications

The Whirlpool CEDC392JQ0 is a highly efficient and reliable electric dryer designed to cater to the diverse laundry needs of modern households. With a sleek design and a range of innovative features, it provides optimal drying performance while ensuring ease of use.

One of the standout features of the CEDC392JQ0 is its impressive drying capacity. This model is equipped with a spacious drum that accommodates large loads of laundry, allowing users to dry more clothes in a single cycle. This not only saves time but also increases overall efficiency in laundry management.

The dryer incorporates advanced drying technologies that promote optimal drying results. The AutoDry sensor drying system is a highlight, which monitors the moisture levels in the drum and automatically adjusts drying time accordingly. This feature helps in preventing over-drying, thus preserving the quality of fabrics while significantly reducing energy consumption.

Another notable characteristic of the Whirlpool CEDC392JQ0 is its variety of drying cycles and temperature settings. Users can choose from multiple drying options tailored to different fabric types, ensuring that delicate items are treated with care while heavier fabrics receive the thorough drying they require. The easy-to-use control panel allows for straightforward selections, enhancing the overall user experience.

Convenience is also a key feature of the CEDC392JQ0. The drum is designed with a lint filter that is easy to access and clean, promoting better airflow and dryer efficiency. Additionally, the dryer operates quietly, making it a perfect choice for homes where noise levels need to be minimized.

The design of the CEDC392JQ0 is both functional and aesthetically pleasing, with a modern finish that complements any laundry room. It includes a stackable feature, offering flexibility in space management for those with limited laundry areas.

In summary, the Whirlpool CEDC392JQ0 electric dryer is an exceptional appliance that combines practicality, efficiency, and user-friendly features. Its various drying technologies, generous capacity, and convenient design make it an ideal choice for families looking to enhance their laundry experience while ensuring that clothes are dried with care. Whether it's everyday garments or special fabrics, this dryer stands out as a reliable solution for all drying needs.
Top Page Image Contents