Whirlpool 3401092 warranty Remove screws before opening top

Page 16

If your dryer is gas and has a full front panel, remove front panel as follows:

1.Unplug the power supply cord or turn off the electrical power.

2.Open lint screen lid. Remove two screws from lint screen area.

3.Open top by pulling forward and up at each front corner (see View A). Rest raised top against wall behind dryer (top is hinged at rear).

4.Remove two internal screws from front panel flanges (near top front corners). Lift front panel slightly, lifting off lower clips (see lower clip inset of View B). Slowly pull front panel forward, disengaging panel from drum. (Drum will drop slightly.)

5.Move front panel aside and rest edge against side of dryer. Avoid disconnecting wire clips (see wire clips inset of View B) or damaging wires.

6.Remove lint from area shown in "gas dryer" illustration on page 15 with soft brush or vacuum cleaner. Avoid damag- ing wires, funnel, or ignitor.

7.Reassemble in reverse order. Before closing the top, check the following:

-Drum seal must be flared out (see drum seal insets of View B) and prop-

erly positioned against panel at back of drum. Rotate drum counterclockwise

one full turn to check drum seal.

-Belt should be centered and tight on dryer drum.

-Wire clips which hold the door switch wires must be anchored in slot in top of front panel (see wire clips inset of View B) and along top edge of side panel. Door wires must not touch drum when dryer is operating. See Warning,

page 15.

8.Replace top panel and lint screen screws. Top and front panels must be securely in place before operating dryer.

9.Reconnect power and level dryer again (if necessary).

Remove screws before opening top

View A

View B

For more information, call our Consumer Assistance Center

24 hours a day.

1-800-253-1301

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Warranty OwToxz Ahoz TMDryer PartsThank you for buying a Whirlpool appliance Please record your models informationYour safety is important to us On nextImportant Safety Instructions Understanding your responsibilitiesParts and Features Operating Your Dryer Before starting your dryerStarting your dryer Stopping/restartingSelecting the right cycle and setting Drying guidelinesTimed Cycles Some items are clampTowels Feature On some models Finish Guard FeatureRack Dry Feature Heavy Dry CycleType of Load Permanent Press SYNTHETICS, and BlendsKnits DelicatesType of Load Fluff AIR Cycle Delicate FabricsRUBBER, PLASTIC, HEAT-SENSITIVE Fabrics Cotton and Canvas ShoesEnd of Cycle signal Clean Touch OrselectorSeparate KnobsRack DRY Cycle Temperature Time Using the drying rackWool sweaters Lint signal Cleaning the lint screenCaring for Your Dryer Cleaning the dryer interior Changing the drum lightExplosion Hazard To change drum lightLint Removing accumulatedElectrical Shock Hazard Remove screws before opening top Choosing load sizes Sorting clothesDrying tips Saving energy Using dryer fabric softenersVacation care Drying special-care items ItemsBlankets and woolens SlipcoversQuilted, down- filled items Snowsuits, jackets Napped itemsTinted, dyed, or noncolorfast items Washable knits Troubleshooting Problem CauseCommon dryer problems If you need service Replacement partsIf you are not satisfied With how the problem Was solved When asking for help or serviceIndex TopicLength of Warranty Whirlpool will PAY for Whirlpoou
Top Page Image Contents