Installation and connection
Connection to the drainage system
The machine drains via a drain pump with a delivery head of 1 metre*. The drain hose must not be kinked as this restricts drainage. The swivel elbow at the end of the hose can be turned in ei‐ ther direction, or can be detached if re‐ quired, with a sharp twist and pull.
If required, the drain hose can be exten‐ ded to a length of 5 m. The necessary parts can be purchased from your Miele Dealer or Miele.
*For a delivery head of more than 1 m (up to a max. of 1.8 m) a replacement drain pump will need to be fitted.
Please contact Miele or your Miele Dealer for advice. If necessary, the drain hose can be extended to a length of 2.5 m. The necessary parts can be purchased from your Miele Dealer or Miele.
Drain hose connection:
1.Direct into a sink or basin. Please note the following:
–Hook the hose over the edge and secure.
–Make sure that the water can drain away freely without hindrance. Otherwise there is a risk of water overflowing or of some of the drained water being sucked back into the machine.
2.Connected securely to a plastic drain pipe with a rubber nipple. There is no need to use a
3.Connected securely to a floor gully.
4.Connected securely to a standpipe. Please note:
Adapter Nut
Hose clip
End of the hose
Fit adapter to the sink drain outlet using nut .
Attach the end of the hose to adapter .
Use a screwdriver to tighten hose clip up close to the nut.
58