IRONING INSTRUCTIONS
CHOICE OF WATER
•This iron can be used with normal tap water.
•If the water in your area is particularly hard, it is advisable to use distilled or
•Do not use chemically
HOW TO FILL IN WATER
•Unplug the iron from the wall outlet.
•Press the steam control button (6) down, so that the steam won’t come out.
•Fill in the water through the inlet.
•Do not fill the water past the maximum level “MAX” of the water tank. This may cause your iron to leak.
Important: Remove the water after use.
TEMPERATURE CONTROL SETTING
•Always check first to see whether a label with ironing instructions is attached to the article to be ironed.
•Follow these instructions in all cases.
•First you should sort the laundry: Wool with wool, Cotton with cotton etc. Start ironing the fabrics requiring the lowest temperature and progress to the higher ones because the iron heats up quicker than it cools down. If the fabric consists of various kinds of fibres (e.g. cotton with polyester) you must always select the lowest ironing temperature for the composition of those fibres.
SETTING THE TEMPERATURE
•Insert the plug into the wall socket and stand the iron upright.
•Turn the temperature control knob (8) to the correct temperature.
•The correct temperature will be reached when the pilot light has turned off. The pilot light will be on and off from time to time indicating that the selected temperature is being maintained.
SPRAYING
This function can be used any time and it does not affect the ironing temperature.
•Fill water into the iron as described above.
•Aim the nozzle to the garment.
•Press the spray button (5)
STEAM IRONING
This function can be used only at a higher ironing temperature.
•2 dots for moderate steam
•3 dots or MAX for maximum steam
MW CO23009GR Eve_IM Folder.indd 3
•Fill water into the iron as described above.
•Stand the iron upright.
•Connect the iron to a suitable mains supply outlet.
•Turn the temperature control (8) to the “2 dots”, “3 dots” or “MAX” setting.
•The pilot light turns off when the required temperature is reached. The iron is ready for use.
•Turn the steam button (6) to the required position, steam starts coming out from the holes in the soleplate.
Note: With conventional steam ironing, water may leak from the soleplate if a too low temperature has been selected. If this happens, turn the temperature control
(8)to the advised position. Steam will recommence as soon as the appropriate temperature has been reached.
DRY IRONING
1.Connect the iron to a suitable mains supply outlet.
2.Ensure that the steam control knob (6) is in position “O”.
3.Select the setting on the temperature control (8).
4.When the pilot light turns off, the required temperature is reached. The iron is ready for use.
CARE AND CLEANING
1.Disconnect the iron from the wall outlet and let it cool down completely.
2.Deposits and other residues on the soleplate can be removed with a rough cloth soaked in a vinegar/water solution.
3.The casting may be wiped with a damp cloth and then polished with a dry one.
4.Never use any abrasives to clean the soleplate.
5.Keep the soleplate smooth: avoid hard contact with metal objects.
STORAGE
•Turn the temperature control (8) to “MIN” and set the steam control knob to position “O” (=no steam)
•Disconnect the iron from the wall outlet.
•Pour any remaining water out of the water tank.
•Stand the iron upright and let it cool down completely.
•The power cord can be wound around the iron.
•Always store the iron in an upright position.
SAFETY PROTECTIVE CUT – OUT
In the unlikely event of the thermostat failing, the protection
5/6/2009 11:06:49 AM