Figure1: Take the main bracket with ironing board part from package. First insert the pole fixing nuts (part 15) into each pole then slide the bracket into the holes at the back of the front cover (Part 18). Then push the two fixing nuts down to secure the bracket firmly.
Figure 2: Inset the 2 shafts of the tilted bracket into the front holes of the front cover, by positioning the black pegged parts into correct position. Push down to fix firmly.
Figure 3: Clip on the two shaft covers (part 24).
Figure 4: Adjust the tilted bracket against the main bracket, align the holes in the two brackets, and then use the metal screws and nuts to secure the two brackets together using part 26. Clip on screw covers. Please use the screws that do not have a plastic washer
Figure 5: Take the two parts of the ironing board and clip them together.
Figure 6: Support the ironing board as shown by inserting the diagonal bar into the clamp.
Figure 7a: The bolts to secure the diagonal support brackets have a plastic washer. This washer must be placed between the two brackets.
Figure 7b: Sort into pairs and clip on the screw covers. The cover with a hole in it is placed on the side where the bolt is, sothat the bolt fits inside the hole.
7 | USK SIT 25803 - 080425 |